Headliner HL10006 Low Profile Flight Case with Wheels for Pioneer DJ XDJ-RX3

Headliner HL10006: The Custom-Fit Rolling Flight Case Built for the Pioneer DJ XDJ-RX3

If you gig with the Pioneer DJ XDJ-RX3, the controller is too good — and too heavy — to throw in a gym bag and hope for the best. The Headliner HL10006 is a low-profile flight case engineered specifically around the XDJ-RX3. The unit drops straight into the custom-cut interior with no front or rear plates to remove and lose, and a 1 in high-density foam lining cradles it on every side. Built from 3/8 in (9mm) plywood with a rugged hexagon laminate skin, it is a true road case sized to one controller — 31.5 x 21 x 9 in on the outside, 28.75 x 15 x 6 in inside, 28 lb empty.

Heavy-Duty Wheels Mean You Roll the Rig In — You Don't Carry It

The XDJ-RX3 already weighs over 12 pounds on its own. Add a hard case and you are hauling real weight across a parking lot, up a loading ramp, and through a crowded venue. The HL10006 puts heavy-duty rubber wheels under the case so you roll it instead of carrying it, then drops onto four rubber feet that keep it planted while you play. For a mobile or wedding DJ doing two or three load-ins a weekend, that is the difference between arriving fresh and arriving wrecked.

Low-Profile Protection Without the Bulk of a Coffin Case

A full coffin case protects your controller but adds bulk and weight you have to store, lift, and fit in the car. The HL10006's low-profile design gives you flight-case-grade protection — steel ball corners, aluminum profiles, recessed spring-loaded padded handles, and recessed butterfly latches with padlock staples — in a slimmer, lighter package. The recessed hardware means nothing snags during load-in, and the padlock staples let you lock the rig down at a venue or in transit.

The Lid Protects the Jog Wheels and 10.1-Inch Touchscreen

The most vulnerable parts of the XDJ-RX3 are the dual jog wheels and the large 10.1-inch touchscreen — exactly the surfaces that get scratched or cracked in a soft bag. The HL10006's easy-locking tongue-and-groove lid carries foam pads on its underside that press gently over the jog wheels and display when the case is closed, so nothing rubs or rattles against the control surface in transit. There is also interior space for cable management, so your power and signal cables travel with the controller instead of getting tangled loose in a backpack.

Who the HL10006 Is For

This case is for the working DJ who moves the XDJ-RX3 for a living. The first-time buyer stepping up from a soft sleeve gets a hard, custom-fit shell that finally protects the screen and jog wheels. The mobile and wedding DJ doing weekly load-ins gets wheels that save their back. The touring or club DJ gets a road case rated for the rigors of land and air travel. If the XDJ-RX3 is your instrument, the HL10006 is how it survives the road. Order yours today.