The Royer R-10 Matched Pair is two R-10 passive figure-8 ribbon microphones, supplied by Royer Labs as a matched set for stereo recording. Each mic has the 2.5-micron aluminum ribbon used in the R-121, handles more than 160 dB SPL at 1 kHz, and protects its ribbon with a three-layer windscreen and an internally shock-mounted transducer. Both mics are hand-built in Burbank, California.

Stereo Setups

Two figure-8 mics cover the classic coincident techniques: a Blumlein pair crossed at 90 degrees, or a mid-side array, where recording mid and side on separate tracks lets you set the stereo width at mixdown. Royer's manual also suggests a spaced pair over the bass and treble strings of a piano, an X-Y pair near the soundboard, and a pair 4 to 6 feet above a drum kit. A pair of R-10s beside a Leslie cabinet is another of Royer's suggestions.

Features

  • Two R-10 passive ribbon microphones, sold as a matched pair
  • Figure-8 pattern suited to Blumlein and mid-side stereo
  • 2.5-micron aluminum ribbon, the same element used in the R-121
  • Handles over 160 dB SPL at 1 kHz
  • Three-layer windscreen protects the ribbon from air blasts and plosives
  • Internally shock-mounted ribbon transducer
  • Custom Royer transformer resists overload at high SPL
  • Humbucking transducer wiring for very low residual noise
  • Patented offset-ribbon design with a brighter back side
  • Ribbon element unaffected by heat or humidity

Specifications

  • Quantity: 2 microphones, matched pair
  • Operating principle: Electrodynamic pressure gradient
  • Polar pattern: Figure-8
  • Element: 2.5-micron aluminum ribbon
  • Magnets: Rare earth neodymium (grade 52)
  • Frequency response: 30 Hz to 15 kHz, +/- 3 dB
  • Sensitivity: -54 dBV (re. 1 V/Pa)
  • Output impedance: 100 ohms
  • Recommended load impedance: 700 ohms or greater
  • Maximum SPL: Over 160 dB at 1 kHz, over 135 dB at 50 Hz
  • Output connector: 3-pin male XLR (pin 2 hot)
  • Dimensions: 149 mm (5 7/8 in) long including mounting base, 35 mm (1 3/8 in) wide
  • Weight: 368 g (13 oz)
  • Warranty: Five years; first re-ribbon free to the original owner within the first year

In the Box

  • 2 x Royer R-10 ribbon microphone (matched pair)
  • 2 x swivel microphone mount
  • 2 x mic sock
  • Aluminum carrying case

ZustandBrandneu (Neu)
Brandneue Artikel werden von autorisierten Händlern oder Herstellern verkauft und kommen in originaler Verpackung.Weitere Informationen
Marke
Modell
  • R-10 Passive Ribbon Microphone Matched Pair
Kategorien
Kabelgebunden/drahtlos
  • Kabelgebunden
Mikrofontyp
  • Bändchen

Möglicherweise sind hier Informationen zur Produktsicherheit verfügbar.

Blackout Audio

Toronto, Kanada
Mitglied bei Reverb seit:2023

Reverb-Schutz

Einfache Rücksendungen, sichere Transaktionen, Support von Experten

Weitere Informationen

Sichere Zahlung

Beworbene ähnliche Inserate













Produktrezensionen

Reverb Gives

Mit deinen Käufen unterstützt du Programme zur Förderung Jugendlicher, damit sie das Equipment erhalten, das sie zum Musizieren brauchen.

Ups, sieht aus, als hättest du etwas vergessen. Bitte prüfe die rot hervorgehobenen Felder.