Genelec 4436A Smart IP 2-Way Pendant Speaker (Black)

Overview

The Genelec 4436A is a 2-way Smart IP pendant speaker for open spaces with high ceilings. It hangs from the supplied 5 m adjustable wire and takes PoE+ or PoE power, Dante or AES67 audio and control over one CAT cable, and a balanced Euroblock input accepts analogue line audio too. A 5 in woofer and a 3/4 in metal dome tweeter each run from a 50 W Class D amplifier for 104 dB short-term SPL. Genelec designed the steel pendant with industrial designer Harri Koskinen, and it is made in Finland.

Key Features

• Single-cable install: PoE+ or PoE power, audio-over-IP and management share one CAT cable up to 100 m long.
• Dante and AES67 input: Plays Dante and AES67 streams at 32 to 96 kHz and 16 to 24 bit, using one channel or the sum of two.
• Analogue line input: 3-pin balanced Euroblock at 10 kOhm, wired in parallel across several speakers if needed.
• Voiced for hanging: The bass is raised to make up for the room gain a speaker loses when it hangs away from walls and ceiling.
• Stored power for peaks: The internal power supply stores energy for audio peaks and reaches 104 dB short-term SPL at 1 m on PoE+.
• Built-in room correction: 20 parametric filters, delay up to 98 ms and level alignment, stored in the speaker.
• Wide coverage: 120 degrees horizontal and 100 degrees vertical dispersion.
• Control: Smart IP Manager for setup, the Smart IP Controller app for day-to-day use and a public API for automation systems.

Specifications

• Type: 2-way active Smart IP pendant speaker
• Woofer: 130 mm (5 in) cone
• Tweeter: 19 mm (3/4 in) metal dome
• Amplifiers: 50 W bass + 50 W treble, Class D (short-term)
• Frequency response (±2.5 dB): 70 Hz - 20 kHz
• High cutoff (-6 dB): 39 kHz
• Max short-term SPL (1 m, PoE+): ≥104 dB
• Max long-term SPL (1 m, PoE+): ≥96 dB
• Max peak SPL (1 m, PoE+): ≥107 dB
• Self-generated noise (1 m, A-weighted): ≤10 dB
• Dispersion (H x V): 120° x 100°
• Crossover: 2.9 kHz
• Latency, analogue input to acoustic output: 2.2 ms
• Network / audio input: 1 x RJ45, 100BASE-TX
• Audio-over-IP formats: Dante, AES67
• Analogue input: 3-pin Euroblock, balanced, 10 kOhm
• Analogue input level for 100 dB SPL at 1 m: -6 dBu
• Max analogue input: 24 dBu
• Room EQ: 20 parametric filters, sensitivity -60 to 0 dB, delay 0 - 98 ms
• Power: PoE+ (IEEE 802.3at) or PoE (IEEE 802.3af)
• Power consumption: Idle 5 W, ISS standby 4 W
• Max CAT cable length: 100 m (333 ft)
• Dimensions: Ø 294 x 237 mm high
• Weight: 5.3 kg (11.7 lb)
• Finish: Black
• Genelec order code: 4436AM

In the Box

• 4436A Smart IP pendant loudspeaker
• 5 m adjustable hanging wire
• Magnetically attached round grille
• Covers for cable entry
• Euroblock connector for analogue audio
• Operating manual