The ADAM Audio Sub10 Pro is an active studio subwoofer with a 10" high-excursion woofer, a 200 W class D amplifier and onboard DSP. It reaches down to 22 Hz (-3 dB) and suits stereo and multichannel monitoring systems that need deeper extension. Phase, crossover and level are set on the backplate or over Ethernet with the free ADAM Control software.

Calibration and Control

ADAM Control manages networked ADAM Audio subwoofers and A Series monitors from one screen. It gives the Sub10 Pro time alignment and four bands of parametric EQ, and loads Sonarworks SoundID Reference calibration profiles onto the subwoofer's DSP. Firmware updates run through the same software.

Connections and Modes

• Analog inputs on two XLR/TRS combo jacks, analog outputs on two XLR
• AES3 digital input and output on XLR, up to 24-bit/96 kHz
• Bass management crossover at 70, 85, 100 or 115 Hz, with a footswitch input to bypass it
• Phase adjustable in 45-degree steps
• Stereo, LFE (120 Hz cutoff for Dolby Atmos) and Wide (full range) modes

Specifications

• Woofer: 10", paper cone, 45 mm voice coil
• Amplifier: Class D, 200 W RMS, 325 W peak
• Frequency response: 22 to 264 Hz (-3 dB), 21 to 300 Hz (-6 dB)
• Max peak SPL: 113 dB at 1 m
• Cabinet: Front-firing, front-ported MDF with a steel grille
• Dimensions (H x W x D): 450 x 360 x 450 mm (17.7 x 14.2 x 17.7")
• Weight: 22.8 kg (50.3 lb)
• Power: 100 to 240 V, 50/60 Hz, 450 W max
• Warranty: 2 years, 5 years with product registration

In the Box

• Sub10 Pro subwoofer
• IEC power cable
• Quick start guide