Toronto, Canada
Informazioni su questo annuncio
The dbx 1215 is a two-channel, 15-band graphic equalizer with 2/3-octave bands on ISO center frequencies. It is built for demanding sound reinforcement and installed systems, with straightforward controls in a 2U steel and aluminum chassis.The 45 mm center-detent faders work over a selectable ±6 dB or ±15 dB range. Each channel has ±12 dB of input gain and a switchable 40 Hz low-cut filter. XLR, 1/4 in. TRS and barrier strip connectors ease installation, and a chassis/signal ground lift helps isolate hum. A hard-wired relay bypasses the unit when the power is off and waits 2 seconds after power-up before switching back in.Features
Two channels of 15-band, 2/3-octave equalization on ISO center frequencies
45 mm center-detent faders
Switchable ±6 dB or ±15 dB boost/cut range
±12 dB input gain range
Switchable 40 Hz, 18 dB per octave Bessel low-cut filter
Electronically balanced inputs and servo-balanced outputs
RF-filtered inputs and outputs
XLR, 1/4 in. TRS and barrier strip connectors
Chassis/signal ground lift
Internal power supply transformer
Power-off hard-wire relay bypass with a 2-second power-up delay
Specifications
Channels: 2
Bands: 15 per channel, 2/3-octave, ISO centers
Input Connectors: 1/4 in. TRS, female XLR (pin 2 hot) and barrier strip
Input Type: Electronically balanced/unbalanced, RF filtered
Input Impedance: 40k ohms balanced, 20k ohms unbalanced
Maximum Input Level: More than +21 dBu, balanced or unbalanced
CMRR: More than 40 dB, typically more than 55 dB at 1 kHz
Output Connectors: 1/4 in. TRS, male XLR (pin 2 hot) and barrier strip
Output Type: Impedance-balanced/unbalanced, RF filtered
Output Impedance: 200 ohms balanced, 100 ohms unbalanced
Maximum Output Level: More than +21 dBu into 2k ohms or greater; more than +18 dBm into 600 ohms
Bandwidth: 20 Hz to 20 kHz, +0.5/-1 dB
Frequency Response: Under 10 Hz to over 50 kHz, +0.5/-3 dB
Signal-to-Noise Ratio: More than 90 dB, ref. +4 dBu
THD+Noise: Less than 0.005%, 1 kHz at +4 dBu
Interchannel Crosstalk: Below -80 dB, 20 Hz to 20 kHz
Boost/Cut Range: ±6 dB or ±15 dB, recessed switch
Low-Cut Filter: 40 Hz, 18 dB/octave Bessel high-pass, recessed switch
Meters: 4-LED bar graph at -10, 0, +10 and +18 dBu
Power Consumption: 24 W
Power Connector: IEC receptacle
Rack Space: 2U
Dimensions (H x W x D): 3.5 x 19 x 7.9 in. (8.9 x 48.3 x 20.1 cm)
Weight: 8.5 lb (3.9 kg)
In the Box
dbx 1215 graphic equalizer
AC power cord
Operation manual
Registration card
Four rack mount screws and washers
PrezzoC$659.99
Politica per i resi entro 14 giorni
Concediti il massimo della tranquillità con il tuo nuovo strumento




