Wounded Paw Battering Ram v2.6 2012 Black

Absolute beast of a pedal. Extremely rare to find one over in the UK. Super hairy overdrive and a tearing monster fuzz. Add an octave up to the fuzz circuit with a separate foot switch and you've got a true weapon of mass destruction. Works well on both guitar and bass, thanks to a low switch. Never been gigged, only ever played at home. A few little marks here and here as shown in the photos, but otherwise works perfectly.

The same circuitry as Battering Ram V2.1 but with the toggle for the octave up on the fuzz replaced by a footswitch.

The Battering Ram is an Overdrive + Fuzz pedal which works equally well for guitar or bass or anything else you want to plug into it. Overdrive + Fuzz means that the overdrive and fuzz channels can work in parallel, each channel receiving the instrument signal, working their magic and then mixed back together at the output. The Overdrive channel with it's Drive, Lo, Hi and Level controls is switched on via the OD/Bypass stomp switch while the Fuzz channel has it's own stomp switch and Tone, Sustain, Octave and Level controls. The Split switch allows the Overdrive and Fuzz channels to be run individually as well.

Stomp on the OVERDRIVE switch and you turn the pedal on and activate the Overdrive channel. It's a smooth overdrive which can go from completely clean to growling distortion via the DRIVE knob.

The LO switch adds in the lower frequencies to make it full-range for bass or other instruments.

The HI knob lets you either boost or cut the highs to dial in the tone you want.

The LEVEL knob on the Overdrive side controls the output volume of the Overdrive channel only.

The FUZZ section is switched on via a second stomp switch and has it's own LEVEL knob to control the Fuzz volume separately from the Overdrive.

The fuzz sound is snarling and raspy and can get right out of control if you crank up the SUSTAIN.

The TONE control goes from high-end cut to flat to a mid-cut, high end boost.

And for another set of sounds there is the OCT stomp switch to change the fuzz section into an octave up fuzz.

Input impedance: 275kΩ

Output impedance: 200Ω

Current draw: 8mA

Heavy Duty 5.7" x 3.7" trapezoidal Hammond aluminum enclosure

True Bypass

Bright blue, orange and red LEDs

Uses standard 9v adaptor like Boss PSA, Godlyke Powerall, Onespot, with tip negative jack or a single 9V battery.