18x6" Flame Maple Modular Pedalboard with 1 Free Generic Pedal Mount - 013

This 18x6” pedalboard is made from custom designed 3D printed sides and flamed maple boards finished in shellac. The 17.5º angle allows for easy pedal viewing and leaves enough room for a power supply underneath (see diagram for dimensions). The multi panel design allows patch cables to be routed underneath and there is a cutout on either side of the unit to allow use of the full 18” of board.

The board can be used with traditional methods for attaching pedals (e.g. Velcro, etc.) but this board has been designed to utilize custom modular 3D printed pedal mounts that can hold pedals from 90mm to 130mm long. They use internal springs to hold the pedals and connect to the board using screws and wingnuts. This is a great way to mount your pedals without the need for Velcro and allows for quick changes/mods.

Board dimensions are shown in the attached diagram and an example layout photo shows roughly how many pedals you can mount (hopefully it goes without saying that the pedals are not included!).

I've included 1 pedal mount and hardware for free. Additional mounts can be purchased separately (see my other listings).