This is a custom-made aluminum knob replacement kit designed to replace the well-known sticky knobs issue on the Korg Minilogue synthesizer.

Please note:
This listing is for the knob replacement kit only.
The Korg Minilogue synthesizer itself is NOT included.

BACKGROUND

After years of use, many Korg Minilogue units develop sticky, deteriorated rubber knobs, which can be very frustrating during operation.

This issue motivated me to design and manufacture a full aluminum replacement kit.
I personally 3D-modeled and produced 10 complete sets, used one set for my own Minilogue, and I put other remaining sets on Ebay. 

All parts are CNC-machined aluminum and silver anodized for durability and a clean finish.

Each knob comes with pre-installed set screws, and a hex wrench is included for installation.

KIT CONTENTS

• 27 standard aluminum knobs
• 1 special knob for PROGRAM / VALUE
• 1 aluminum pitch bend slider
• 1 dedicated CUTOFF FILTER knob
• 1 hex wrench for tightening set screws

INSTALLATION (HOW TO)

1. Remove the original sticky knobs by gently pulling them off.
2. Install the new aluminum knobs.
3. • Please note that the CUTOFF FILTER and PROGRAM / VALUE knobs have different form factors.
   • There is one piece each for these specific controls.
4. Tighten the set screws using the included hex wrench to securely clamp the knob onto the potentiometer shaft.

SHIPPING

• Domestic and international shipping available
• Shipped via express mail service by default(I can change shipping option if needed. i.e. slower but cheaper option)
• Carefully packed for safe delivery