Shutup & Play Studios:
We only sell products we love and would use ourselves. We stand behind and support the business and companies we believe in and want to see stick around.

Controls:

Phase: Use this to select the output phase of the channel. Sometimes other pedals and various instruments will invert the phase of the signal which causes major problems when mixing with other non-inverted signals. If you have a signal that is inverted, flip the phase switch to “–” and the polarity will be corrected. In most cases this switch should stay in the “+” position.

Level: Adjusts the output volume of the channel.

TECH SPECS:

Dimensions
4.75 x 2.50 x 2.25 in. (121 x 64 x 57 mm) with knobs

Current Draw
50 mA

Input Impedance
1 MΩ

Output Impedance
100 Ω

Power

This device takes a standard 9 volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!

The Story

The Four to One Mixer is a simple and compact 4 channel mixer with independent level controls and selectable phase for each channel. This device features a high 1 MOhm input impedance and a low 100 Ohm output impedance ensuring all signals maintain their sonic integrity throughout their journey, even on long cable runs. The Four to One Mixer was primarily designed to be used with our One to Four Splitter to create 4 parallel signal paths, but it can be used just about anywhere you need to mix four different sources into a single output!

Shutup & Play is an Authorized EarthQuaker Effects Dealer and Reverb preferred Seller

Guy Eckelberger 
Professional Organic Pedal Farmer since 1976. 
Member and Founder-Tone Farmers Union since 1961