Pedalboard 8ch Bypass Stereo Looper Power Supply Flight Case Pedal Racks

Nice stereo looper and road case combo, everything functions as it should. Heavy duty flight case but the front and rear exterior plastic covering is pulling up and probably wouldn’t hold up to much travel use. My plan was to remove some of it up and reglue the rest to give it an old road worn look for an analog board I was building but I’ve run out of room. Holes drilled for George L’s to be run underneath, looper holes are useable but some of the holes in the center of the board are now blocked by some extra support that was added to beef things up. Solid now.

Last photo shows the original configuration from Pedal-Racks, you can see the power supply under the Morning Glory. Tuner switch shown is not included, I've used it elsewhere. PEDALS NOT INCLUDED

Originally a custom made pedalboard from the early days of Pedal-Racks, the board was covered in that same thin plastic road case material that also broke apart and peeled up, board has since been replaced and I’ll include the custom made 9v power supply it was built with. It’s too thick to fit underneath so they originally cut a hole and countersunk it from the top of the board and mounted a pedal on top. No base for the looper, never was one. They just cut a hole in the bottom of the metal case, pedal is attached via 2 screws through the top and into a pair of countersunk nuts in the board. 

23.75x14” useable board space with approximately 3.5-4” interior depth with lid. Overall case dimensions are 25x17x6 

8 loops

Mono in

1-6…mono

7…mono in stereo out

8…stereo in and out

Stereo out

Check my other listings for more stuff