This piece of gear has sold
View similar gear from other sellers on Reverb
Watch this gear and we'll notify you if it becomes available again.
Nanosynth + Nanobridge package in very good condition. Everything in perfectly working order, however the 3.5mm audio out jack has a cracked plastic housing (see pictures). Comes with patch wires!
A full analogue modular system with multiple waveforms, LFOs, logic circuits, attenuators, switches, a freaking touchstrip, and more!
-------------
We at soundmachines thought about a simple and cheap platform that will transport the main characteristic of a modular analog synthesizer in a small and friendly format, to be well recognised by musicians, makers and tinkerers worldwide. A small, but loyal to its roots, instruments of sound creation. With a digital platform added as a bonus.
The soundmachines NS1nanosynth is born.
The NS1nanosynth synthesizer is an handeld 220x85mm analog modular synthesizer coupled with an Arduino Leonardo platform.
Power Supply is 5v/160mA either from the USB micro connector or the classic 5.5mm barrel jack, central positive. If you use use both concurrently, power will be drawn from the barrel jack.
Feeding the NS1 with more than a regulated 5V will result in immediately destruction of most part of the product (i.e. holy smokes + swears).
On board the synth, +12 and -12 voltages, necessary for the oscillator and the filter, are generated through a DC/DC module.
All CV control signals are 0-5V unipolar. Oscillator waveforms outputs are equally 0-5V to be able to use the on board modules to mix cv and audio signals without problems (see the ‘waveshaping’ video for an example of this).
------
The NS1nanobridge is the definitive companion that allows the NS1nanosynth to interface to any eurorack or other modular system. With its 14 3,5mm jacks and optional protections on signals, the NS1nanobridge is the best solution to spread the nano strain.
You have, for each connection, a protected and unprotected nanopatch header. To have a fully working protected connection from the external system to the NS1nanosynth (that handles 0V to 5V voltages) connect the “0V” and “5V” nanopatch points to the same patch p0ints on the RIGHTMOST connector header on the NS1nanosynth. This way you will limit the excursion of the incoming signal from 0V to 5V. To achieve this we put a resistor-diodes limiting circuit on each pin. Alternatively, and this is useful for two purposes: outgoing signals (from NS1 to modular) and incoming V/oct pitch, you can use the ‘unprotected’ header side.
| Listed | a month ago |
| Condition | |
| Brand | |
| Model |
|
| Categories | |
| Made In |
|
| Analog / Digital |
|
