Gibson 5-pin Quick Connect Adapter for 57 Classic / Dirty Fingers / Burstbucker 3 / Throbak / Tony Iommi / Widdershins

Easily connect your 57 Classic, Dirty Fingers, Burstbucker 3, Throbak, and other compatible pickups to Gibson Les Paul and SG electronic control boards (2012-era and newer) with these adapters. Each adapter is handcrafted using quality 24 AWG hook-up wire and pre-wired for a clean low-noise signal path. The installation process is simple: just match the wire colors, solder the connections, and protect them with the supplied heat-shrink tubing.

Key Features:

• Direct‑fit Gibson 5‑pin Quick‑Connect plug for solderless PCB integration
• Compatible with Gibson 57 Classic, Dirty Fingers, Burstbucker 3, Throbak, Tony Iommi and Widdershins pickups
• 7-inch (18 cm) lead length for clean routing and easy installation
• Restores the convenience of plug‑and‑play pickup swaps on PCB‑equipped Gibsons

Note:
These adapters are designed exclusively for Gibson models that use the factory 5‑pin quick‑connect system. Before placing your order, please inspect your guitar control cavity and compare it with the reference photos provided in this listing to confirm compatibility. If you have any questions or would like help verifying fitment, feel free to contact me anytime.

Installation tips:
Using these adapters requires some basic understanding on the basics of guitar wiring. When installing your new pickups with the quick-connect adapter, follow these quick steps:

• Match Wire Colors: Connect the pickup wires to the adapter harness by matching them color-for-color.
• Test Before Soldering: To verify everything works, tightly twist the wire connections together by hand. Slide the heat-shrink tubing over each temporary joint, ensuring absolutely no exposed wires touch each other or the cavity shielding. Test the guitar through an amp to confirm your signal and switching.
• Watch Pickup Orientation: Physical orientation is critical. To avoid unwanted out-of-phase issues, ensure the neck and bridge pickups are facing opposite directions (typically, the adjustable screw coils face outward toward the neck and bridge, while the solid slug coils face inward toward each other).

What you will get:
2 - 5-pin Quick Connect Adapters for direct plug-in to Gibson 5-pin Control Board Header Connectors. 10 - 1-1/4 inches, 2 mm diameter heat shrink tubing to insulate all soldered connections.
2 - 2 inches, 5 mm diameter heat shrink tubing cable sleeve to protect and reinforce all connections.
1 - Drawing for end-user wiring reference.