The Walrus Audio Canvas Reamp is a studio tool, designed to send previously recorded dry guitar tracks, drums, or other instruments through guitar pedals or different amp combinations.

Features:

- Flat frequency response from 20 Hz to 20k Hz.

- Custom wound transformer that converts your signals impedance to work with guitar pedals and amplifiers.

- Converts 1/4" balanced line level output from your DAW/Interface to unbalanced 1/4" Hi-Z output to pedals or amps.

- Input 1/4" Jack: connect a 1/4" cable from your audio interface output.

- Input XLR Jack: connect an XLR cable from your audio interface output.

- Output Jack - 1/4" cable to pedalboard or amplifier of choice to re-amp through.

Specs:

-Volume: Control the level of the re-amp signal being sent back into your pedalboard/amp.

-GND Lift: Isolates the GND pin on XLR input to help reduce hum if present. Leave out for normal operation.

-MUTE: Mutes the output signal when pushed in. Leave out for normal operation.

-PHASE: When pushed in your signal will be phase inverted by 180 degrees. Leave out for normal operation.

-HPF: Applies a gentle first order high-pass filter at 200 Hz to reduce low frequency rumble in your signal.