ADCOM GFR-700 A/V Receiver Power Amp w/Original Remote

ADCOM GFR-700 A/V Receiver Power Amp w/Original Remote.

Sounds great. Lots of settings. You can reset with remote and unit.

Original remote included. 
One of the front feet was missing. I put two others on it. I will include the 1 original foot.

Manual is available online.

Features

• 125 watts per channel 
• Massive, linear toroidal transformer-based power supply 
• Comprehensive set of desirable, usable features and surround modes, including Dolby Digital EX, DTS ES and Pro Logic IIx 
• Upgradable: Hardware and software-addressable for accommodation of future advancements 
• S.A.F.E. (Self Annealing Fuse Equipped®): Protected from external faults and low-voltage situations 
• HDMI™ video switching 
• Upconverts composite and S-video to component 
• Flexible bass management & system calibration 
• Independent Room 2 Out with advanced equalization

Specifications
Preamplifier Analog Section

Input Impedance : 47kilohms 
Output Impedance (Main-RCA) : Less than 600 Ohms 
Rated Input : 1.0 Volt rms 
Maximum Input (@ 4Vrms Input Sens.) : 4.1 Volts rms 
Rated Output (100k load) : 2.0Vrms 
Minimum Load : 5 kilohms 
Maximum Output : 8Vrms 

Volume & Trim Range (relative to 0 dB Trim) 
• Main : -80dB to +18dB (0.5dB res) 
• Main Trim : -10dB to +10dB (1.0dB res) 
• Main Input Sens./Input : 1V/2V/4V 
• Room 2 : -65dB to +0dB (1.0dB res) 
• Room 2 Trim : -8dB to +8dB (1.0dB res) 
• Room 2 Gain/Input : +0dB to +6dB (2.0 dB res) 

Channel Separation (at 1kHz) : (>65dB) 
Frequency Response 
• Analog DSP Input : 20Hz to 20kHz +0/-0.2dB 
• Analog Ext7.1 Input : 20Hz to 100kHz +0/-0.2dB 

THD+N (@ Rated Input & Output) 
• Analog DSP Input : 0.007% (20kHz Low Pass) 
• Analog Ext7.1 Input : 0.006% (80kHz Low Pass) 

S/N Ratio (ref. 2.0Vrms A-weighted) 
• Analog - DSP Input : 93dB 

• Analog - Ext 7.1 Input : 100dB 

Preamplifier Digital Section 

Frequency Response 
• Digital Input : 10 Hz to 22 kHz +0/-0.2 dB 

THD+N (@ Rated Input & Output) 
• Digital Input : 0.009% (A-weighted) 

S/N Ratio (ref. 2.0 Vrms A-weighted) 
• Digital Input : 99 dB Bass Management (Front/Center/Surround/Sub) 
• High-Pass Slope Crossover Frequency 
• (Small Spkr Setting) : 12dB/octave (2nd order) (Adj. 40/60/80/100/120/150Hz) 
• Low-Pass Slope (Sub) : 24dB/octave (4th order) (Adj. 40/60/80/100/120/150Hz) 
• Delay Mgmt (Feet or Meters relative 1ms/ft) 
• Front/Center/Surr/Surr Back/Sub : 0-20 ft 
• Lip Sync Delay : 0-169 mS 

FM Tuner Section

Sensitivity 30 dB S/N : 6 dBμ typ. 
S/N Ratio 
• Mono : 65dB typ. 
• Stereo : 55dB typ. 

Distortion 
• Mono : 0.3% typ. 
• Stereo : 0.5% typ. 

Stereo Separation : 35dB typ. 
Adjacent Channel Selectivity : 50dB typ. 
Frequency Response : 50Hz to 15kHz +1/-3dB

Amplifier Section 

Frequency Response : 10 Hz to 50 kHz +0/-3 dB 
THD+N : 0.009% 
S/N Ratio : 93 dB 

Power Output (x # = number of channels driven) 
• EIA/CEA 490-A (8 Ohm x 5) : 145 Watts 
• EIA/CEA 490-A (4 Ohm x 5) : 265 Watts 
• RMS (8 Ohm x 5) : 109 Watts 
• RMS (4 Ohm x 5) : 148 Watts 
• RMS (8 Ohm x 2) : 150 Watts 
• RMS (4 Ohm x 2) : 226 Watts 

Damping Factor 
• RMS (8 Ohm x 1) @ 50Hz 1% THD : 102 
• RMS (4 Ohm x 1) @ 50Hz 1% THD : 51 

Video Section 

Impedance (Input/Output) : 75 Ohm 
Bandwidth 
• Composite & S-Video : 6MHz -3dB 
• Component : 200M Hz -3 dB 

Transcoding 
• Composite/S-Video/Component : 480i & 576i 

Switching 
• HD Component (Auto Bypass) : 480p-1080p 
• HDMI (Switching Video/Audio/ DDC/HPD) : 80i-1080p 

General

Supply Voltage (Switchable) : 120 VAC-60Hz/ 230 VAC-50Hz 
Power Consumption : 1200 Watts maximum 
Dimensions 
• Width : 17 inches (431.8 mm) 
• Rack Height : 7 inches (177.8 mm) 
• Full Height : 7.5 inches (190.5 mm) 
• Depth of Chassis : 15.5 inches (393.7 mm) 
• Full Depth : 9 inches (482.6 mm) 
Unit Weight : 50 lbs. (22.7 kg) 

Trigger Outputs 
• Main : 50mA @ 12vDC 
• Room 2 : 50mA @ 12vDC 

IR Inputs 
• Main : 3.5mm T/R 
• Room 2 : 3.5mm T/R