Socal Pedalboards Red Oak Pedalboard with two mounted Voodoolabs Pedal Power 2 PLUS power supplies

A beautiful (and deceptively light) wood pedalboard with two Voodoolabs Pedal Power 2 PLUS power supplies (powering a total of 16 pedals) mounted underneath.  Great compact rig!

Pedalboard:
17 ½ x 13 inch platform and overall size is 19 1/8 x 14 inches.. Red oak stain, set of rubber feet, drilled holes for 1/4 jacks (two on the right side and one on the left) and flanged power inlet (on the right side) (POWER INLET OR JACKS NOT INCLUDED). Light and sturdy. Hand Made in USA by Socal Pedalboards.

Power supplies: (each uses toroidal power transformers and comes with 8 cables; each has a courtesy AC outlet; purchased in 2017/2018)

9/12V (x4) – Standard 9V and 12V Boss ACA
With each one of these four outputs delivering 100mA, you can easily power any 9V battery-operated pedals. Boss pedals that specify the PSA adapter operate at 9V like most other pedals. Boss pedals that require the ACA adapter operate at 12V which can be selected via switches underneath the Pedal Power 2 PLUS. Any one of these outputs can be individually selected to run at 9V or 12V.  

9V (x2) – High Current 9V and Line 6 Modelers
These two outputs each deliver 250mA allowing you to run high current draw effects like the Boss DD-20 Giga Delay or Line 6 DL4 Delay Modeler. Via switches underneath the Pedal Power 2 PLUS, these two outputs can be separately configured for regulated (Boss Twin Pedals) or unregulated (Line 6 Modelers) power allowing you to run both units if so desired. These outputs can also power any standard 9V effects as well.    

9V (x2) – Standard 9V With Battery Sag Control
These outputs each have an available 100mA of power, but also allow you to SAG the voltage from roughly 4V to 9V. This feature can be enabled via the bottom panel switches. The SAG control is mostly useful for transistor-based fuzz, octavia, and distortion circuits, as most modern opamp designs are minimally affected by variations in supply voltage. We recommend turning SAG off if you’re going to run digital pedals like delay, chorus, and reverb.

18V/24V – Using Custom Cables
All of the outputs on the Pedal Power 2 PLUS (and the original Pedal Power) are completely isolated allowing you to create different voltages. You can run effects like the current MXR Flanger by combining two 9V outputs to create a single 18V supply. By switching two outputs into 12V ACA mode, you can join them together to create a 24V output for powering numerous Electro-Harmonix stompboxes including the Deluxe Memory Man.

There are a few pieces of hook and loop underneath the pedalboard which can be used to attach additional utility pedals.  There is a hole at the top side of the board and on the bottom side to allow for passage of cords that won't fit through the spaces on the platform.