Yamaha RS7000 sampler sequencer with 64MB RAM + original Yamaha 8MB Smart Media card. The 8MB card is loaded with the original factory set.
Note that you need the smart media card to save samples and projects. So this is a $25 bonus.
Fully tested by going through the factory test menu. Please see test items below and screenshots. Everything works. All buttons are responsive. All controls work well.
Note that when the master volume knob turned Below Half Way, the right output is a little softer than the left output. When turned up Above halfway, this issue disappears.
Physical condition as shown. Please inspect all pictures. This unit is marked 100V Japanese version. However the power supply is good for 100-120V AC. This is confirmed by looking up the service manual. Please note if you intend to use this with 220-240V AC, you will need to use a step down transformer.
Sale is for the device only, plus a 8MB Smart Media memory card. No power cord or other accessories included.
Shipping worldwide.
$88 via postal airmail to USA, France, Germany, Netherlands, Denmark, Norway, Poland, Japan, Asia.
$118 via EMS to Canada, Australia, New Zealand, Belgium, Czech Republic, Italy, Spain, Sweden, Switzerland
Factory test items performed:
1. RAM battery : OK. Tested at 3.1V 2. LCD, LED blink : This make all LCD pixels and LED blink. All good 3. LED : Goes through all LEDs and light them up one by one. All good 4. Panel switches, rotary switches : Check all switches. All very responsive. No sticky buttons or keys 5. Encoders 1--4 : OK. Tests all encoders. No skipping observed 6. Knobs 1--22 : All OK. All knobs turn to max (127), then back down to 0. All passed test. 7. Pads 1--2, foot switch : Velocity pads checked OK. Foot switch OK 8. MIDI IN/OUT A : OK. This performs a MIDI loopback test from OUT back to IN and checks data received is the same as sent 9. MIDI IN/OUT B : OK. MIDI loopback test on port B 10. 1 kHz OUTPUT L sound : Test tone sound out OK 11. 1 kHz OUTPUT R sound : Test tone sound out OK 12. A/D -> D/A (MIC) : Mic input test on both L/R inputs OK 13. A/D -> D/A (LINE) : Input test OK for both L/R inputs OK 14. Card : OK. Smart Media test passed 15. SCSI : I do not have SCSI device to test 16. Digital In -> D/A : This requires the optional AIEB2 card, which is not installed on this unit 17. Optical In -> D/A : This requires the optional AIEB2 card, which is not installed on this unit 18. SIMM : OK, 32MW (32MegaWords, which is 64MB RAM) 19. SIMM (Full) : Full write/read of installed memory. 20. SYSTEM ROM, Wave ROM : OK. ROM IC self check passed 21. SYSTEM RAM, Wave RAM : OK. System RAM self check passed 22. Factory set : Factory reset performed 23. Exit : Exit out of test menu