The EarthQuaker Devices Avalanche Run V2 Delay and Reverb Pedal is a dreamy stereosonic exploratory multi-tool that includes up to 2 seconds of delay time, reverse delay, tap tempo with subdivision control, switchable true bypass, or buffered bypass with 5 different tail lengths (including a sound-on-sound style lo-fi looping mode) and an assignable expression control that maps the expression jack to control of your choice, including the toggle.

Ergonomics

The delay section allows tweaking from tape emulation to bucket brigade styles with a twist of the wide-range Tone control. The cavernous, plate-style reverb has just a touch of modulation similar to the one found in our precious Dispatch Master only more lush with an adjustable Decay. Otherworldly reverse delay and dynamic swelling reverb settings are accessible through a 3-way toggle switch

Time

This controls the delay time and goes from 0ms to just under 2000ms

Repeats

Controls the regeneration of the delay, from zero repeats to near infinite

Tone

Controls the tone for the delay line only. Roll-off highs to the left, roll off lows to the right and get a flat response in the middle

Mix

This is the volume control for the delay line. This blends in the wet with dry until 1 o’???clock, 1 o’???clock to 3 o’???clock boosts the wet signal over the dry, and 3 o’???clock up brings down dry until it is fully wet when up.

Expression Jack Assign Switch

Use this switch to map the expression jack to one of the assigned controls. The decay control helps control the reverb decay length. The R mix controls the reverb mix

Time

This takes over for the delay time control and is drastically different than the interface control. Using the expression pedal to control the time will give you all kinds of wild effects that can not be achieved by turning the knob

Toggle

This takes over for the toggle switch and will crossfade from forwarding delay in heel down position to reverse delay in toe down position

Ratio Selector Switch

Selects delay subdivisions when time is set by the 'Tap' switch

Decay

Controls the decay length of the reverb, short decay counterclockwise, long cavernous decay clockwise.

Mix

This is the volume control for the reverb. It blends in the wet with dry until 1 o’???clock, 1 o’???clock to 3 o’???clock boosts the wet signal over the dry, and 3 o’???clock up brings down dry until it is fully wet when up