Seymour Duncan TS-2b Triple Shot Arched Les Paul Bridge Mount Ring Cream

• Triple Shot Arched Switching Pickup Bridge Mounting Ring, Cream
• For Les Paul and Similar Guitars with Arched Tops
• Four Way Switching: Series, Parallel, or Either Coil
• Made in USA

The Seymour Duncan TS-2 makes wiring mods easy with four different sounds at tips of your fingers. This is the arched model for the bridge position, designed for Les Paul and similar guitars with arched tops. See the specs below for dimensions.

The Seymour Duncan TS-2 for Les Paul Humbuckers allows you to expand your tonal palette by accessing three unique tones from a humbucker, thanks to the TS-S mounting ring that holds two small switches. For use with nearly any humbucker pickups with four-conductor cable on Les Paul guitars, Seymour Duncan or otherwise.

This "stealth" pickup switching device allows you to access series, parallel and split wirings with a standard humbucker. And it's easy to install. Just solder your pickup leads to a small color-coded circuit board. That's it. Push the two switches towards each other for standard series wiring; away from each other for parallel wiring; and both towards one coil (either one) to shut that coil off.

Specifications

Inside: 2.780 x 1.470 inches
Outside: 3.54 x 1.78 inches
Pickup mounting hole spacing: 3.076 inches on center
Trim ring mounting hole spacing: 3.20 x 1.513 inches on center
Height: 0.426 inches (ring), 0.554 inches (switch casing)
Circuit board: 1.353 x 0.402 inches
Soundboard Radius: 20.4

Note: Will not fit Nickel and Gold covered Trembuckers.

Product Details