Gronlund R16 Bolt-On Body loaded with McNelly P90 pickups

Made in my shop in Maine.   Awesome body, just been sitting for a couple years and I’m not planning to finish it as I’m really making only set neck stuff now.  I don't have a neck made for it and no longer plan to make one.  It's completely wired and ready to rock with the addition of a neck.  The neck pocket exactly fits the bolt pattern and shape of a telecaster neck heel.  However, there are a couple important differences. 

One:  The neck pocket is 3/4" deep rather than the usual 5/8" fender depth.  So in order to use an existing Tele/Strat neck you will need to shim it to bring the heel up and to give a slight angle appropriate for the wraparound bridge.  I think that two or three of the neck pocket shims that Stewmac sells stacked up will do the trick - Or you could of course make a nice fitted shim out of maple or ebony or the like. 

Two:  The bridge location is intended for a 24.75" scale neck.  So intonation would be off with a typical 25.5" fender tele neck.  A 24.75" Warmoth conversion neck may work perfectly, I'm just not positive on that.  You'd have to try it.  A fully adjustable wraparound bridge will also swap right onto the existing studs.  A Warmoth 24.75" conversion neck and a fully adjustable wraparound may be the ticket, again just not positive.  You could alternatively make your own neck.  You could even relocate the bridge if necessary.

Body: 2 Piece Spanish Cedar. Solid body.

Lower Bout Width: 13.25"

Electronics: 1 Volume Control, 2 Tone Controls, 500K Bourns Pro Audio Pots. Orange Drop Capacitors .022uf. Switchcraft output jack.

Bridge: Kluson USA Uncompensated Vintage Style Wraparound

Scale Length: 24.75"

Finish: Satin Nitrocellulose Lacquer. Cherry Red.

Pickups: McNelly P90s

Weight: 5 lbs 10 ounces