![Frequency Central - Stasis Leak [Pedal] [CLEARANCE] image 1](https://rvb-img.reverb.com/image/upload/s---vx3Kf_E--/a_0/f_auto,t_large/v1618865213/e55i3ctgx2orplopd1nx.png)
This listing has ended
View similar gear from other sellers on Reverb
Watch this gear and we'll notify you if it becomes available again.
DSP based chorus/tap delay/plate reverb pedal
Description
Stasis Leak is a 48kHz DSP effects pedal, providing a choice of chorus, plate reverb and tap tempo delay. Stasis Leak is based around a Belton ABE-FX sub board, which in turn is based around a Coolaudio V1000 chip. Designed to fit in a 1590BB enclosure.
Tone control
This knob works on each of the three different effects as a simple lowpass filter, cutting the highs in the effected signal, and helping to provide definition between the dry and wet signal.
Wet control
This knob controls the amount of effected signal that is mixed with the dry signal. Dry is always 100%.
Tap
This function applies to the delay effect, where it may be used to set the delay time.
Time & Density
ChorusDelayReverbTime knob LFO rate Time sub-divisions* Pre-delay Density knob Depth Repeats Decay
*Delay time (50 – 1000 ms). – Tap more than once within 1 second to set, LED blinks at quarter-note tempo, and the time knob is divided into 4 tempo subdivision:
The chorus section consists of two parallel sections which are 90 degrees out of phase with each other. This results in a rich chorus effect. These two sections are mixed internally and output as a mono signal.
| Condition | |
| Brand | |
| Model |
|
