Seismic Audio - 2 Space Pro Audio DJ Road Rack Case - Pro Tour Grade 2U Vertical Amplifier

When you're hauling power amps and processors to gigs week after week, you need a case that won't fall apart when roadies throw it around or when you're cramming gear into a van at 2 AM. The SA-PTR-2U handles that reality without breaking your back or your budget.

Built with 3/8" plywood instead of cheap particle board, this 2U case gives you real protection at 26 pounds — heavy enough to feel substantial, light enough that you won't dread carrying it up three flights of stairs to the venue. The front and rear doors both come off completely, so you can strip it down for permanent installs or keep everything buttoned up for transport. Those dual 4" steel locks on each door aren't just for show — they'll keep your gear secure when the case is stacked in storage or bouncing around in the trailer.

The 22" interior depth with doors on handles most power amps and processors you'll encounter, though you can pull the rear door for deeper gear or better ventilation. Four steel L brackets per side reinforce the structure where cases typically fail, and the spring-loaded handles with rubber grips won't dig into your hands when you're carrying a loaded amp.

This isn't a flight case — it's a road case designed for the realities of regional touring, club gigs, and mobile setups where you need protection but can't justify the weight and cost of ATA cases. If you're running a single power amp, a compressor/gate combo, or a DJ controller setup, this case keeps things organized and protected without taking over your entire load-in.

Bottom line: If you need bulletproof protection for 2U gear without the bulk and weight of larger cases, the SA-PTR-2U delivers professional-grade construction at a price that makes sense for working musicians.

Technical Specifications

• Model: SA-PTR-2U
• Rack Spaces: 2U
• Construction: 3/8" plywood with laminated exterior
• Mounting Rail Width: Standard 19"
• Exterior Dimensions (H x W x D): 5" x 21" x 28"
• Interior Depth (doors on): 22" rail to back
• Interior Depth (doors off): 19" rail to rear edge
• Front to Rear Rail Distance: 17.5"
• Weight: 26.1 lbs
• Hardware: Heavy-duty twist latches, spring handles
• Security: Dual 4" steel link locks per door
• Reinforcement: 4 steel L brackets per side
• Doors: Front and rear removable
• Finish: Black with chrome trim
• Recommended For: Power amps, processors, effects, DJ gear

Frequently Asked Questions

Will my power amp fit in this 2U case?

Most standard 2U power amps will fit fine — the 22" depth with doors on handles QSC, Crown, Peavey, and similar amps. If you're running something deeper or need rear ventilation access, just pop the back door off and you're good to go. The case accommodates any standard 19" rack gear up to 2U high.

How much gear can I safely load into this case?

The case itself weighs 26 pounds empty and can handle typical 2U loads up to 50-60 pounds total. That covers most power amps, processors, and effects units you'd rack together. The plywood construction with steel reinforcement handles the stress better than cheaper cases that crack at the corners.

Do I really need both doors, or can I run it open?

Depends on your setup. Keep both doors for transport and storage — they're your protection against dings and dust. Pop the front door for permanent installs where you need constant access to controls. Remove the rear if your gear runs deep or needs ventilation. The doors are completely removable, so you've got options.

How does this stack up against flight cases for my needs?

This is a road case, not a flight case — it's built for van tours and regional gigs, not airline cargo holds. You get solid protection at half the weight and cost of ATA flight cases. If you're flying with gear regularly, invest in proper flight cases. For everything else, this handles the abuse without the overkill.