Amber Overdrive
Fat and juicy overdrive sounds with a hint of fuzz
FAT AND SMOOTH OVERDRIVE
Amber Overdrive is a fat sounding pedal in Mad Professor Hand Wired
Custom series. One of the most sought-after guitar tones is a
combination of a great overdrive or fuzz pedal into overdriven tube
amplifier.
Amber Overdrive produces this sound even when running through a clean
amplifier. It produces a very thick sound whether playing chords or
single notes – fat and juicy with just a hint of fuzz. Though highly
saturated, this dynamic overdrive can be cleaned up with the volume
control of your guitar. As with all Mad Professor pedals, it offers a
wide range of dynamics and expressive touch sensitivity. When you plug
it into a clean amplifier, Amber Overdrive can give you the massive
sound of a saturated amplifier with classic smooth fuzz running wide
open. It can also be used as a slightly distorted boost to increase
saturation on slightly overdriven amplifiers.
Amber Overdrive is great for getting fat singing tone out of vintage
low output single coil pickups. It works really well with Fender
Telecaster and Stratocaster guitars and with P-90 pickups.
Of cource is shines too with humbuckers.
Amber Overdrive is hand made in Finland using only premium components,
to give years of trouble free operation with superb musical tone. Build
the Mad Professor way: small footprint and big tone.
Best overdrive pedal for: Fat lead tones, Eric Johnson tone, David Gilmour tone, Leslie West tone, long sustain, little fuzz
CONTROLS:
VOLUME: This knob sets the overall output level of the pedal.
DRIVE: Settings from low to the center will allow you to control the
saturation with the volume control on the guitar. To use amber as light
overdrive set this control at the beginning of the rotation.
TONE: This is a boost/cut “shelving” type equalizer that controls the
amount of high end, operating somewhere between a bright switch and the
treble control on most amplifiers.
TONE: Turning this counterclockwise reduces the amount of high end. If
you must run a buffered pedal ahead of Amber Overdrive try lowering the
treble.
ELECTRICAL SPECIFICATIONS:
Current draw: 2.5mA at 9V DC
Input impedance: 45K
Output impedance: 25K
Voltage range: 7.5-12Vs
POWER REQUIREMENTS:
6F22 9V battery or DC eliminator 2.1 mm plug center negative and
positive sleeve.
EAN: 643003309 028 2