EMG 25k Solderless B124 LONG SPLIT SHAFT Tone Control Pot (3243.00)
Price$18
Free Shipping
from Pittsburgh, PA
1
3 in stock
Listed:over a month ago
Views:130
Watchers:3
Pittsburgh, PA, United States
About This Listing
EMG 25k Solderless B124 Long Shaft Tone Control Pot ,Split Shaft (3243.00)
The B124 Passive Tone control is included with original EMG Pickups and Pickup Systems. There are two versions, 25K Ohm for Active EMG’s and 500K Ohm for EMG-HZ Passive Pickups. The 25K Ohm control has a black PC Board, the 500K has a green PC Board, both are Audio Taper. The wiring configuration is the same for both 25K and 500K Controls. The tone capacitor is small and is mounted on the pot side of the PC Board. There are 4 header pins, (2 pairs of signal and ground) the two pairs are identical so either can be used for tone control with the second pair for in/out. Examples are shown in the included diagrams. The B124 features plug-in compatibility with all EMG Pickup Systems by using .100 (2.54mm) standard pin spacing. You can solder to the control by using the 2 solder pads on the PC Board if connectors are not available, 1 of the solder pads is for input and the other pad is for ground, see below.
Long Shaft- 19mm
| Condition | |
| Brand | |
| Model |
|
About the Seller
About This Listing
EMG 25k Solderless B124 Long Shaft Tone Control Pot ,Split Shaft (3243.00)
The B124 Passive Tone control is included with original EMG Pickups and Pickup Systems. There are two versions, 25K Ohm for Active EMG’s and 500K Ohm for EMG-HZ Passive Pickups. The 25K Ohm control has a black PC Board, the 500K has a green PC Board, both are Audio Taper. The wiring configuration is the same for both 25K and 500K Controls. The tone capacitor is small and is mounted on the pot side of the PC Board. There are 4 header pins, (2 pairs of signal and ground) the two pairs are identical so either can be used for tone control with the second pair for in/out. Examples are shown in the included diagrams. The B124 features plug-in compatibility with all EMG Pickup Systems by using .100 (2.54mm) standard pin spacing. You can solder to the control by using the 2 solder pads on the PC Board if connectors are not available, 1 of the solder pads is for input and the other pad is for ground, see below.
Long Shaft- 19mm
| Condition | |
| Brand | |
| Model |
|