Klavis FLEXSHAPER Eurorack VC Waveshaper and CV Transfer Function Processor

CV-controlled voltage mapper and waveshaper - perform transfer functions on CV or audio sources for clipping, frequency multiplication and wavefolder like effects, and use voltage to transform existing CV into new shapes! Insert an audio rate oscillator and bend into all new shapes, or insert a CV source to turn it into a different but related wave

Flexshaper is a deep module but also deceptively simple. Use the gain knob to set the incoming CV level, including to a clipping point to add harmonics. Ceiling and floor knobs set the minimum and maximum voltage output level, rounding out sources that approach the ceiling and floor rather than clipping. Halfway knob sets the midpoint between the floor and ceiling, and mid up and mid down control the response to those points. Each of these parameters can be modulated, including at audio rate, for huge waveshaping possibilites at audio rate or extreme transfer function bending for CV signals!
Features:

• Process from DC to full audio range
  
  
• Unipolar/bipolar input mode switch
  
  
• Nominal & clip level LEDs
  
  
• Output signal LED
  
  
• Input gain setting for nominal level setting, allows clean flat clipping when overdriven
  
  
• Five manual voltage mapping potentiometers
  
  
• Five CV control of the voltage mapping points
  
  
• Simultaneously active unipolar and bipolar outputs
  
  
• Firmware update via a simple audio file
  
  
• Compact and skiff-friendly module
  
  

Specifications:

6hp
6 mA +12V
7 mA -12V
32 mA 5V
21 mm deep