Promoted similar listings













Selling my custom Jazzmaster guitar. The body was made and aged by MJT and the neck is a solid rosewood/ebony fretboard made by Musikraft. Pickups are Klein’59’s, tailpiece is an actual ‘59 era and bridge is a Mastery. This guitar plays and sounds great and has a great feel. I just sings. This is a great combination neck and body that really resonates well. A lot of these “partscasters” neck/body wood don’t really match up well but this is one of the exceptions. You can really feel it playing it unplugged, then plug it in to an amp and you’re in tone heaven. I would never dream of selling except that a severe hand injury has forced me to sell most of my instruments. No case included but will be securely packaged for shipping. Detailed specs are noted below:

Body:
This is a Swamp Ash official MJT® Custom Vintage style Aged Nitro VTJ Guitar Body. The body was cut to vintage style specs by Wildwood Manufacturing in California USA. The body is topped off with an aged vintage 100% nitro Sonic Blue finish by Mark Jenny of MJT® Aged Guitar Finishes. This body weighs in at only 4 lbs 2 oz!!

Neck:
Musikraft solid Indian rosewood with ebony fingerboard.
Options:
ORIENTATION: Right for Right Handed Players
SCALE LENGTH: 25.5 Standard Fender
NUMBER OF FRETS: 21 Fret
NUT WIDTH: 1.650 (41.91mm)
HEEL WIDTH: 2-3/16 (55.56mm) Standard Fender
TUNER HOLE SIZE: 11/32 Vintage Kluson
TRUSS ROD TYPE: Single Acting Adjust at the Heel
FB RADIUS: 10
12TH DOT SPACING: Wide (Vintage Pre 64)
NUT SLOT STYLE: 1/8 Standard Fender Flat Bottom Style
SHAFT WOOD: Indian Rosewood
FB WOOD: Ebony AA Grade
FB STYLE: Slab Standard Fender
TOP DOTS: Mother of Pearl
CUSTOM INLAY: None Use Dot Inlay Selected Above
SIDE DOTS: Mother of Pearl Larger 3/32
SIDE DOT LOC: 50/50 Split (Middle of Finger Board Glue Joint) Slab and Veneer
FRET WIRE SIZE: 6150 Medium Jumbo Nickel Silver
FB EDGES: Heavy Rolled Non Bound Only
BACK PROFILE: Boat V 95 95
BINDING: None
FINISH: Hand rubbed Danish oil
FB FINISH: Raw

Pickups:
Klein '59 Jazzmaster pickups(From the Klein website)
100% 1959 Vintage Jazzmaster Reproduction
What You Get In Your Pickups:
-1959 Original Alloy Magnets*
-1959 Original Spec 42ga Enamel Wire*
-1959 Neck & Bridge Outputs
-1959 Wind

*Original Alloy Magnets & Original Spec wire have been independently analyzed from Original Pickups.

Tuners:
60's Grover rotomatic w pearl tuner buttons

Bridge:
Mastery

Pickguard:
Rare "Scotland Guard" vintage relic style Jazzmaster pickguard. 13 hole.

Tremolo:
vintage '58-'62 "pat pend" tremolo

Wiring and electronics:
Rothstein Guitars 1958 Vintage Reproduction
Professional Grade Prewired Jazzmaster Kit
+ Uptone Audio Musicap - Made in USA /
5% Tolerance / Film & Foil Capacitor
We take great pride in producing the finest and most reliable wiring harnesses you can put into your Jazzmaster. Our world famous, professional grade assemblies have been used by countless touring professionals. We go the extra mile to ensure the peace of mind of our customers who will not have to worry about our electronics "crapping out" during a gig
CTS pots - in the vintage correct value and taper, and tested to be within 5% tolerance. Lead circuit uses 1M linear volume, 1M audio tone; Rhythm circuit uses 1M linear volume and 50K linear tone.
All pots are treated with Caig DeOxit for long trouble free operation.
.033 uf Uptone Audio Film & Foil Musicap in the lead circuit - These are the bomb!! MusiCaps are manufactured entirely in the USA with tight 5% tolerances. They are hand soldered and constructed using separate layers of premium foil and polypropylene films, and they have silver plated copper leads. They provide a dramatic improvement in clarity, focus and dynamics.
Mallory 150 series .022 uf cap in the rhythm circuit - This is the famous Mallory Mustard Cap used on many high end guitars. They are tubular metalized polyester caps and are quite smooth sounding.
Treble bleed mod- Please read our article about this. This is critical to prevent the loss of highs as you lower your volume. We use a 1000 pf Mallory 150 series cap in parallel with a 150k resistor.
Switchcraft right angle toggle switch
Switchcraft slide switch
Switchcraft jack
Vintage style "push-back" cloth wire in ALL 6 of the period correct colors (red, blue, green, yellow, black, and white)
Bracket (for roller pots)
Roller Knobs
A thin PVC wire is included for you to ground your bridge
Components are prewired using high-end Kester Solder.

Neck plate:
Ron Kirn vintage spec 1959 aged neck plate

Reverb Buyer Protection

Reverb has your back if your item is lost, damaged, or doesn't match its description. Simply report any issues within 7 days and we'll help you get a full refund.Learn more about Reverb Buyer Protection.

Promoted similar listings













Listed7 years ago
ConditionVery Good (Used)
Very Good items may show a few slight marks or scratches but are fully functional and in overall great shape.Learn more
Brand
Model
  • Jazzmaster
Finish
  • Sonic Blue
Categories
Body Type
  • Solid Body

Product safety information may be available here.

About the seller

The Echo Location

Bellingham, MA, United States
Joined Reverb:2014

Reverb Gives

Your purchases help youth music programs get the gear they need to make music.

Oops, looks like you forgot something. Please check the fields highlighted in red.