ABC MIXER is a channel selector that allows you to send the signal of 1, 2 or 3 instruments to the three outputs simultaneously. It has three footswitches, one for each input. It has the added advantage of being active and all channels are independent and separated by isolation transformers.
Each input has a Volume control, which allows you to adjust and match the volume of different instruments. Accepts both active and passive instruments. The output volume of each instrument depends directly on the type of pickup it has.
Because it is an active pedal, there is no loss of input signal when the three inputs are used at the same time. The signal volume and performance will be identical on the three outputs in the same way it was entered. The isolation generated by the transformers will not allow any ground loops if you use an amplifier with a faulty ground. The channels are equipped with an independent Ground switch.
When using more than one amplifier, there is the possibility that the second (or third) amplifier is out of phase with the first. You can easily repair this by turning the Phase Reverse switch at the back of the pedal next to the outputs. The channel selector offers low impedance outputs to drive long guitar/bass cables without the loss of signal. SEND / RETURN with Blend control. Share your pedals with all the inputs, and control how much effect will pass with the Blend control.
Independent Phase and Ground controls per output.
All the outputs (Out 1, Out 2 and Out 3) work simultaneously, but not independent.
LEDs will indicate the inputs that are active: A, B or C or ABC.
- Volume control per input (maximum gain is 5dB)- Ground / Lift for each output- Phase inversion for each output
- 3 Inputs: A, B, C- Send/Return with Blend control
- 3 simultaneous and isolated Outputs:
OUT 1: is a Balanced DI output and accepts 3 types of cables:
1/4 TRS Balanced
1/4 TS Unbalanced
XLR Balanced DI
Only one cable should be used at a time on OUT 1
OUT 2: 1/4 TS Unbalanced
OUT 3: 1/4 TS Unbalanced.
All the outputs (Out 1, Out 2 and Out 3) work simultaneously, but not independent.
POWER- 9VDC-500mA: power supply connection 9 volts DC, center pin negative. Boss style adapter - Not included.
- Cold-rolled steel case. Powder Coat Finish- Dimensions – 5,42″ (D) x 7,86″ (W) x 2,36″ (H) (138mm X 200mm X 60mm)- Handmade in Brazil
