2 quick-connect adapters for 1 or 2-conductor single, humbucker hb, p-90 p90, pickups, solderless

In this listing: 2 (1 pair) quick-connect adapters used to solder onto your 1 or 2-conductor (2 or 3 wire) single coil, humbucker, or P-90 pickup leads enabling you to plug your pickups into a PCB harness with the black 2-pin (2 holes) quick connect receptacles (see pics, especially the 2nd pic).

Before ordering, it is advisable to compare all of the pics above to the pickup to PCB quick connections inside your guitar.  By removing the control cavity cover on the back of your guitar, you should see that your stock pickups have the larger black quick connectors / receptacles (2 pins), as you see in the pics above.  If your guitar has the smaller white 5-pin connectors, see my other listings for that adapter.

These are hand made in Phoenix, Arizona. Vintage-style cloth-covered push-back hookup wire is crimped and soldered to the metal contacts. The soldered contacts are then inserted into the connectors and finished with heat-shrink tubing. The ends that you will solder to your pickup leads are pre-tinned for easy soldering.

Both leads of each adapter have been tested for continuity. Included is heat shrink tubing to insulate your connections after you have soldered them.

Be sure to slide the shrink tubing onto the wire BEFORE soldering, then use a lighter or heat gun to shrink the tubing for nice clean connections.

These adapters should work for just about any 1 or 2 conductor (2 or 3 wire) single coil, humbucker, or P90 pickup, provided the harness that you are plugging into has the black 2-hole quick-connect female receptacles (see pics).

NOTE:  BLACK IS HOT, WHITE IS GROUND. If you have 3 wires, solder pickup hot to adapter black and solder the other two pickup wires to adapter white.