Promoted similar listings













Jamo 507 Floor standing speakers - Red Mahogany - One Owner - Mint Condition

This was a big project that took almost 6 months to finished. Many items came from USA, Germany and England and sometimes took long time to received. Jamo 507 is a tall speaker but no space inside for large coils and caps, so we did a lot research to finished this project. The total cost was high, parts and labor but the improvement was 100% way better than we expected, voice sounds much clear and now you can heard details more precise with high mids and deep bass. Jamo use bad and low budget components in his crossovers. This Jamo 507 model sell around $900 to $1100 and these ones has a crossover upgrade (No budget) that costs $680 in parts and labor. (No junk over here like some that you can find in other sites)

Full Crossover Upgrade with High End Components - Complete List:

Mundorf ECAP100 Capacitors:

(8) Mundorf ECAP100-82 | 82 µF | 5% | 100 V

(2) Mundorf ECAP100-56 | 56 µF | 5% | 100 V

Jantzen Audio Standard Z-Cap Crossover Capacitors :

(2) Jantzen Audio 10uF 400V Standard Z-Cap Crossover Capacitor

(2) Jantzen Audio 6.8uF 400V Standard Z-Cap Crossover Capacitor

Jantzen Audio Bypass Amber Z-Cap C&B Pure Copper Foil Capacitors:

(4) Jantzen Audio 0.01uF 630V Amber Z-Cap C&B Pure Copper Foil Capacitor

Mundorf M-Resist Supreme Resistors:

(2) Mundorf M-Resist Supreme 3.3 ohm Resistors

Jantzen Audio Air Core Inductor Crossover Coil:

(2) Jantzen Audio 0.35mH 20 AWG Air Core Inductor Crossover Coil

(2) Jantzen Audio 0.90mH 18 AWG Air Core Inductor Crossover Coil

(4) Jantzen Audio 5.4mH 18 AWG Air Core Inductor Crossover Coil

Audtek 100 ft. 16 AWG Stranded OFC Twisted Pair Speaker Cabinet Hookup Wire Red/Black

Cardas Audio Soldering Wire Quad Eutectic Silver Solder with rosin flux 1/4 lbs (110g)

Chemtronics 80-4-5 Soldering Spool

The Danish-made Jamo 507 is next to the top of the company's new "07" line of loudspeaker systems. That it is not just another me-too design is immediately apparent: Standing 36 inches high and weighing a solid 42 pounds, the speaker has front and back panels only 5 inches wide. Curved sides, finished in mahogany, give the cabinet a maximum width of 8-3/4 inches, and a 1/4-inch-thick glass plate covers the top. The speaker is supplied with spikes whose use is optional but recommended by Jamo. Rubber feet are also furnished for installation on hard floors such as wood or stone.

  • Manufacturer: Jamo
  • Model: 507
  • Year of manufacture: 1997
  • Made in: Denmark
  • Color: Red Mahogany
  • Dimensions: (W x H x D) 22.5 cm x 91.5 cm x 36.5 cm - W 8.85" x H 36.02" x D 14.37")
  • Weight: 42 Pounds Each
  • New price approx: 4000 Euro
  • Technical Data
  • Type: 3-way bass reflex
  • 1x 25 mm tweeter
  • 2x 102 mm midrange driver
  • 2x 165 mm woofer (mounted in the body)
  • Power handling (nominal/music): 150/200 W
  • Efficiency: 90 dB
  • Frequency response: 40 Hz to 20 kHz
  • Transient response: (for LS with multiple drivers)
  • Impedance: 4 Ohm
  • Cover made of 1/4"- tinted thick glass plate covers

The front is covered by a two-section black cloth grille. The lower part, which is purely decorative, is not removable. The upper grille, retained by small built-in magnets at its sides, lifts off easily to reveal two 4-inch cone drivers flanking a 1-inch soft-dome tweeter. These drivers handle frequencies above 150 Hz, with a 3-kHz crossover between them.

The range below 150 Hz is handled by a pair of specially developed 6-1/2-inch cone woofers mounted between two chambers within the enclosure. One chamber is closed, while the other radiates into the room through a ducted port on the rear of the cabinet. The two woofers are mounted in a push-pull arrangement, which Jamo says enables them to work as though they were in a much larger enclosure.

Also on the back of the cabinet is a recessed connection panel containing two pairs of gold-plated binding posts suitable for use with single or double banana plugs, lugs, or wire ends. They are normally strapped together with removable jumpers for conventional connection to the amplifier. With the jumper straps removed, the bass and upper-frequency drivers can be fed via separate cables from a single stereo amplifier (biwiring) or from two separate amplifiers (biamplification).

Jamo rates the Model 507 for operation at power levels up to 150 watts (200 watts for short-term peaks). Its nominal impedance is 4 ohms, its frequency range 40 Hz to 20 kHz.

We measured the room response of the two Jamo 507's with the speakers installed about 7 feet apart, 1 foot from the wall behind them and 4 feet from the side walls. Jamo recommends placing their backs close to a wall for best bass performance and points out that their narrow front panels minimize high-frequency diffraction that could cause response irregularities.

The averaged room response of the two speakers was very smooth and uniform over most of the audio range. The woofer response spanned just over one octave, from approximately 40 to 115 Hz, falling at 24 dB per octave below 50 Hz and at about 30 dB per octave above 100 Hz. The output of the two midrange drivers joined the woofer output at 110 Hz, and their combined response was +/-4 dB from 40 Hz to 3 kHz.

The system's composite response, based on close-miked measurements of the low-frequency and midrange drivers and the total room response of o all of the drivers, was flat within +/- 2.5° dB from 700 Hz to 20 kHz and +/-1.8 g dB from 700 to 46 Hz. There was a double-humped peak of 3 or 4 dB in the 12- to 16-kHz range that we later confirmed with quasi-anechoic MLS response measurements. The tweeter had the good high-frequency dispersion typical of 1-inch dome radiators: At 45 degrees off-axis, it was down 6 dB at 10 kHz and 10 dB at 20 kHz.

The system impedance fell to a rather low 2.6ohms at 120 Hz but averaged close to 4 ohms between 100 Hz and 1 kHz. It climbed at high frequencies to about 12.5 ohms at 20 kHz. As with most other multicavity bass radiators we have tested, the phase component of the impedance measurement was ragged below about 250 Hz (probably not of any audible significance).

Sensitivity was, as rated, 90 dB sound-pressure level (SPL) at 1 meter with an input of 2.83 volts of pink noise. At that level, the woofer distortion was between 0.9 and 1.5 percent from 110 Hz to 42 Hz, rising to 9 percent at 30 Hz-impressive performance from a speaker with the Jamo 507's driver complement. The small drivers were also able to absorb large short-duration power peaks without damage or excessive distortion. The tweeter and midrange drivers were not harmed by single-cycle tone bursts of 650 watts at 10 kHz and 1,050 watts at 1 kHz. A 100-Hz burst of 645 watts drove the woofer cones to their limits, adding a "hard" quality to the sound, but caused no damage.

As is our usual practice, we listened to the Jamo 507's for some time before performing any measurements. Their smoothness and wide range were obvious from the first moment. After several days of listening, the measurements were not too surprising, merely confirming this unconventional speaker's excellence. It was interesting to feel the sides of the cabinet while it was reproducing low frequencies. When we played a 31,5-Hz test tone at a room-filling level, there was hardly a trace of vibration to be felt on the exterior of the cabinet, yet the output was obviously mostly the fundamental, not harmonics of it-something not usually experienced from a pair of 6-inch cones.

Jamo says the cabinet's sides are a sandwich of grooved chipboard and conventional medium-density fiber-board (MDF). When the two boards are glued together, they form an arc-shaped, extremely rigid structure with thoroughly damped resonances. As our listening confirmed, that results in a "dead" cabinet with a minimum of sound coloration.

Over the years, I have seen and heard, and sometimes tested, quite a few unconventional, innovatively designed and constructed speakers. Unfortunately, their sound quality has rarely correlated with their special features, or with their often high prices. The Jamo 507 is a happy exception-a tastefully styled, ingeniously designed, and thoroughly listenable speaker. All things considered, it is not unreasonably priced, and we were very impressed with its performance. Hear it if you can.

Reverb Buyer Protection

Reverb has your back if your item is lost, damaged, or doesn't match its description. Simply report any issues within 7 days and we'll help you get a full refund.Learn more about Reverb Buyer Protection.

Promoted similar listings













Listed5 days ago
ConditionExcellent (Used)
Excellent items are almost entirely free from blemishes and other visual defects and have been played or used with the utmost care.Learn more
Brand
Model
  • 507
Finish
  • Red Mahogany
Categories
Year
  • 2000
Made In
  • Denmark

Product safety information may be available here.

About the seller

Gerald's Gear Depot

Lauderhill, FL, United States
Joined Reverb:2020

Reverb Gives

Your purchases help youth music programs get the gear they need to make music.

Oops, looks like you forgot something. Please check the fields highlighted in red.