Mighty Mite Vintage Amber Neck for Tele, Indian Rosewood fingerboard

Shaped, inlaid, fretted and finished—looks and plays great! Hard rock maple with a thin, vintage tint finish, and an inlaid "skunk stripe" down the back.

Other features include:

• Thin polyurethane finish
• Slotted and shaped PPS plastic string nut, with flat bottom
• 22 frets
• Indian Rosewood fingerboard
• Peghead-adjustable truss rod (for 4mm Allen wrench)
• Traditional dot inlays
• Without mounting holes, so you can drill to fit your body
• Peghead drilled for 6-in-line tuning machines, with 10mm-diameter holes that fit sealed gear tuners with threaded peghead bushings.

Specifications:

• Scale length: 25-1/2" (647.70mm)
• Width at nut: 1-11/16" (42.86mm)
• Width at 22nd fret: 2-3/16" (55.56mm)
• Fretwire: .045" high x .095" wide (1.14mm x 2.41mm)
• Fretboard radius: 9-1/2" (241.30mm)
• Fret count: 22
• String post spread: 4-11/16" (119.06mm)
• Approximate heel length: 3-5/8" (92.07mm)
• Fits neck pockets measuring 2-3/16" (55.56mm) wide x 3" (76.20mm) long x 5/8" (15.88mm) deep.

Neck thickness (approximate; not including fret):

• .860" (21.84mm) at the 1st fret
• .880" (22.35mm) at the 6th fret
• .890" (22.61mm) at the 12th fret

Ideally, the neck should just drop into the neck-pocket, or be a little snug. Don't force the neck into the pocket. If the body is unfinished, remember that the finish will make the neck pocket smaller with lacquer build up on the edge of the rout. Be sure to compensate for the finish buildup or the neck will be too tight after finishing.