Carpenter Studio Gear The Fader 8U Adjustable Studio Rack Stand 16" Deep | Height and Angle Adjustable Wood Rack

The Fader: a handmade 8U studio rack on an adjustable stand, built to order in Portland, Oregon. Push it up, pull it down, tilt it toward your chair or roll it all the way over to reach the back panel, then lock it in place with a quick turn of the knobs.

No more reaching across a desk or crouching under one. Your gear meets you at the right height and the right angle, with direct access to every knob, meter and patch point.

DETAILS

• Fits standard 19 inch rack gear, 8 rack spaces (8U)

• 16" deep cabinet, measured outside front to back; the rack rails sit 1/4" behind the front edge

• Adjustable height: set the rack higher or lower on the stand to suit your chair, your desk or standing sessions

• Adjustable angle: tilt it to any angle or rotate it a full 360 degrees, and lock it with the hand knobs on each side

• The rack arrives fully assembled, and the stand goes together with no tools and no screws

• Baltic birch plywood with glued rabbet joints that stay tight for years

• Four hand-finished colors: Natural, Caramel, Chocolate or Charcoal. Send us a message with your finish after you order (see the finish photo)

• Free shipping in the US

A 12" deep version and other sizes are in our shop. Need something custom? Send us a message.

Handmade in Portland, Oregon • Built to order in about 2 weeks • Built by a musician and woodworker