Wall Mounted Synthesiser Arms Music Studio Brackets

Wall Mounted Synthesiser Drum machine Sampler etc Arms Music Studio Stand...

Build your own wall mounted Jaspers rack equivalent!

Suitable for a wide range of gear up to approx 400mm total depth.

Bracket Lip is 15mm, please check suitability of your equipment.

For heavier items we recommend using multiples of arms, additional arms can also be provided.

Bolt holes are 6mm diameter with a 10mm washer indent.  Fittings not included, recommended using secure wall anchors/plugs and tightening down by hand.

These have had luggage scales hooked to the lip pulling at 30kg per arm without issues, but individual suitability for equipment is as per buyers discretion.

Mounted with anti-slip pads on the arm face and lip edge for additional grip.

Because we don't just make plastic triangles, we also care, not only about your instruments, but also the world at large. 

Our new studio workshop is powered by a combination of solar and wind.  

Our raw materials (PLA) are mostly plant based and bio-degradable.

All items are made to order using 3D printing technology in our studio workshop, please allow up to 5 days for despatch during busy periods.

Instructions for assembly included.  These are SUPER TIGHT snap fit stands.  We recommend placing the strut braces on the corner of a hard surface and pushing the frame slot down firmly onto the tab to assemble.  Should you have any questions or issues with the fitting of the braces then please message us as we're always happy to help!

These arms are made, and used, by ourselves, using high quality PLA. Printed to a layer height of 0.16 mm with a high density infill.

Please check our other listings for great value studio solutions.

Many thanks