XTA Electronics DNA120 Amplifier

Now you don’t have to choose between the highest quality amplification, and digital audio networking convenience. Or between incredible power and the ability to work within analogue or digital systems. You can have it all.

Dante Card: We can add provide the Dante module/version, just message us for a cost

Shipping: Listed shipping is likely higher than actual to cover all regions. Send us a ZIP or Postal Code and we can provide accurate cost

The DNA Series offers the assurance of XTA’s highest quality audio power amp technology with future proofing via the inclusion of simple to use digital audio networking.

Fast rear panel switching allows the amplifier to accept either four channels of analogue audio or pick up four channels of networked audio, via Dante, which is then converted using 24 bit 96kHz DACs.

Connect to an DPA amplifier using a single CAT5 cable to realise a stereo 4 way system with no further external processing required. Switch back to analogue to use as a powerful traditional quad channel amplifier. Run bridged channel pairs or link adjacent inputs for total flexibility in either analogue or digital mode.

Specs
Output Power (per channel):

8R         2400W x 2

4R         4600W x 2

2.7R       6250W x 2

2R         6800W x 2

Output Power (bridged):

8R         —

4R         —

THD: (@1dB below maximum output power)    @ 1kHz            <0.08%, [        <0.18%]
@ 20Hz to 20kHz            <0.1%, [    <0.2%]

Gain / Sensitivity:
Gain        32dB
Sensitivity (for maximum power)
+10.7dBu (2.7V), [8.3dBu (2.0V)]

Frequency Response:
20Hz to 20kHz (+0.5dB)

Dimensions:
Amplifier
(2U) (mm)    88(h) x 482(w) x 458(d)
Boxed (shipping size – UK)         230 x 580 x 560 (Single boxed)

Weight:
DNA100:
12.5kg (27.6lbs), Boxed (shipping) 14.5kg (32.0lbs)

Front Panel:
1 x Power Switch, 1 x STBY LED (orange)
4 x 6 point LED level indicators,
4 x level controls
3 x Channel Audio LINK LEDs (yellow)
1 x PROTECTION LED(red),
2 x BRIDGE LEDs (green)
1 x POWER LED,
1 x ANALOGUE LED,
1 x NETWORK AUDIO LED (3 x yellow)

Rear Panel:
4 x Neutrik Speakon output connectors
(4 pole)
4 x Neutrik XLR female connectors
(audio input)
2 x Ethernet RJ45 (Audio Network)*
3 x Channel Link Switches
2 x Bridge Mode Switches
1 x Analogue/Network Source Select Switch

*Dante Audio Network is a factory fit option

System:
Mains voltage: 115/230VAC nominal 50-60Hz
(factory set for either 115 or 230V operation)
Mains current: 20A maximum
Suggested circuit breaker: C32
Mains connector: PowerCon

++Powers measured for continuous music with Crest Factor of 4.8 (14dB)

*2.7 ohm power quoted for highest single ended output and greatest efficiency (3 x 8 ohm parallel drivers).   Amplifier is stable with 2 ohm loads but output will be reduced.