Toronto, Canada
Informazioni su questo annuncio
The Blackstar St. James 50 EL34 is a 50-watt, two-channel 1x12 tube combo that weighs 12.8 kg (28.2 lbs), made for guitarists who play on stage, record at home and sometimes need to practice in silence. A Celestion G12Z-70 Zephyr lightweight speaker keeps the weight down. Its EL34 power tubes and British-voiced second channel suit classic clean and crunch tones, and an internal reactive load with Blackstar's Cab Rig speaker simulation sends a miked-cabinet sound to the XLR, headphone and USB outputs, with or without a speaker connected.
Two Channels
Channel I takes its cue from mid-'60s American amps. It is very clean and bright, with a solid low end and controlled mids, and its tight, linear power stage makes it a good base for pedals. Channel II on the EL34 models is based on an early-'60s British Class A amp. It is a low to medium gain preamp that can stay clean, turn warm or break into a mild overdrive, and selecting it sets the power stage to open loop for a looser feel, a resonant low end and lively highs. The footswitchable Boost adds 10 dB of clean gain at the input to push the preamp from chime into a thicker overdrive. The Bass, Middle and Treble knobs use dual-gang pots, so each channel gets its own EQ circuit tuned for its voicing, and on Channel II the Middle works as an active cut and boost that leaves the tone flat at center.
Power Settings, Silent Recording and Cab Rig
A three-way switch runs the output stage at the full 50 W for stage use, at 2 W for practice, recording and small gigs, or in Sag mode, which adds power supply sag for a softer, more vintage response on hard attacks. Setting the Standby switch to 0 disconnects the speaker outputs and loads the power tubes with the internal reactive load, so the whole amp stays in the signal path while you record or play through headphones in silence. Cab Rig is Blackstar's DSP speaker, microphone and room simulator. A rear switch recalls three stored settings, and Blackstar's Architect software opens 23 cabinets plus a DI setting, six microphone models, room types and EQ for deeper editing.
Features
50 W tube amplifier with 2 x ECC83 and 2 x EL34 tubes
Two footswitchable channels, with a footswitchable Boost on Channel II
Bass, Middle and Treble with a separate EQ circuit for each channel
Digital reverb with level control
50 W, 2 W and Sag power settings
Master volume for all outputs
Internal reactive load for silent recording and practice with the Standby switch at 0
Cab Rig DSP speaker simulation on the XLR D.I., stereo line out / headphone and USB outputs
USB audio output that needs no drivers, also used to edit Cab Rig in Blackstar's Architect software
Effects loop with a +4 dBu / -10 dBV level switch
Universal power supply, 100 to 240 V, 50/60 Hz
12-inch Celestion G12Z-70 Zephyr lightweight speaker
Speaker outputs for adding one 16-ohm extension cabinet
Illuminated Blackstar logo
FS-19 2-way footswitch included
Specifications
Power: 50 W RMS, switchable to 2 W, with Sag mode
Tubes: 2 x ECC83, 2 x EL34
Channels: Channel I, Channel II with Boost
Speakers: 1 x 12" Celestion G12Z-70 Zephyr, 16 ohms
Front panel: Input, Volume I, CH. II switch, Gain II, Boost switch, Volume II, Bass, Middle, Treble, Reverb, Power switch (50W / Sag / 2W), Master, Standby, Power
Rear panel: Mains input, 1 x 16 ohm speaker output, 1 x 8 ohm or 2 x 16 ohm speaker outputs, XLR D.I. output, 1/4" TRS line out / phones, Cab Rig switch, effects loop send and return, effects loop level switch, footswitch, USB-B
Effects loop level: +4 dBu or -10 dBV
USB: USB-B audio output, no drivers required (cable not supplied)
Mains input: 100 to 240 V AC, 50/60 Hz
Finish: Fawn
Dimensions (W x H x D): 535 x 462 x 259 mm (21.1 x 18.2 x 10.2 in)
Weight: 12.8 kg (28.2 lbs)
In the Box
Blackstar St. James 50 EL34 combo amplifier
FS-19 2-way footswitch
Detachable mains power cord
PrezzoC$1,769
Spedizione gratuita
Spedizione gratuita
da Toronto, Canada
Politica per i resi entro 14 giorni
Concediti il massimo della tranquillità con il tuo nuovo strumento




