G-Storm Electro Jupiter-6 VCF Eurorack Module Roland Clone

This is a Roland Jupiter-6 filter clone in Eurorack.
Uses two IR3109 OTA chips like the original.
24 db/oct low pass, 24 db/oct high pass, 12 db/oct band pass.
Mix together two different input oscillators with the dual audio input jacks w/ signal attenuation/gain pots.
These inputs can be over-driven just like the original.
Mix together two different input control voltages using the two CV input jacks w/ signal attenuation pots.
Illuminated Frequency and Resonance Slider controls.
There are trim pots on PCB for adjusting frequency and resonance response.
Each module is painstakingly prototyped and assembled by hand including PCB and face plate.
Therefore each unit may vary slightly and have minor surface/graphic imperfections.
Includes power connector cable.
Be aware this module is most likely NOT skiff boat compatible due to its depth. Refer pics, and the specs below to make sure it will work in your rack.
Thanks for looking!
Specifications:
Inputs - 2 Audio Inputs, 2 CV Inputs
Outputs - 1 Mono Output
Current - 60mA +12V, 20mA -12V, 0mA +5V (not used)
Depth - 95mm