Purpose-designed angled desktop stand pair for the Pioneer DDJ-RZX professional DJ controller.
The DDJ-RZX is a particularly large and substantial controller, so this stand was developed around its actual chassis rather than adapted from a smaller laptop or compact-controller stand.
Each support provides an 18-inch / approximately 457mm rail beneath the controller.
Although the maximum external depth of the DDJ-RZX is greater than 457mm, that measurement includes the raised rear screen housing. The support rails sit beneath the complete main chassis footprint while the screen section extends behind them.
FEATURES
• Designed specifically for the Pioneer DDJ-RZX• Supplied as one left and right support pair• 18-inch / approximately 457mm chassis support length• Supports the complete underside body of the DDJ-RZX• Raised rear screen housing remains clear behind the rails• Three desk-contact points beneath each support• Additional central foot helps distribute the controller’s weight• Independently positionable to suit the chassis• Raised front retaining lips• Angled working position• Open underside for ventilation and cable access• Designed and manufactured by Studio Solutions
REINFORCED FOR A LARGE CONTROLLER
Each side includes an additional central support foot.Feet and surfaces are fitted with anti-skid and anti-slip rubber contacts.
This spreads the load across three points per rail rather than relying only on the front and rear ends of the support.
The stand should be placed on a rigid, level desk, with all six feet resting fully on the surface.
COMPATIBILITY
Primary design compatibility:
• Pioneer DDJ-RZX
The supports may also be dimensionally suitable for other large Pioneer DJ or AlphaTheta controllers, including:
• Pioneer DDJ-RZ• Pioneer DDJ-SZ• Pioneer DDJ-SZ2• Pioneer DDJ-FLX10• Pioneer XDJ-XZ
These secondary models have not necessarily been physically tested.
Please compare the underside feet, chassis shape and cable positions of equipment other than the DDJ-RZX before ordering.
POSITIONING
Space the supports evenly beneath solid areas of the controller chassis.
Check that:
• The controller rests securely against both front lips• All six stand feet contact the desk• Ventilation openings remain unobstructed• Rear cables are not trapped or sharply bent• The desk is itself suitable for supporting the controller
Designed and manufactured in our UK studio workshop. See our website for further provenance.
Equipment shown or mentioned is not included.