Yamaha MGX16 B 22-Channel Digital Mixing Console High-Output Live Sound Bundle with 2x DBR12 12-Inch 1,000W Powered Loudspeakers

Yamaha MGX16 B Live PA Bundle: A Complete Mixer-and-Speaker System That Goes Loud

This bundle pairs the Yamaha MGX16 B 22-channel digital mixing console with two Yamaha DBR12 12-inch 1,000W powered loudspeakers — a complete, self-contained PA built for bands, worship teams, and event producers who need real output in a mid-size room. The MGX16 B is the brain: 8 MGX premium mic preamps, a 4.3-inch touchscreen, a 22-in/22-out USB audio interface, onboard 16-track microSD recording, and Bluetooth audio input. The DBR12 pair is the muscle: 1,000W of Class-D power per cabinet, 131 dB max SPL, and Yamaha FIR-X tuning that stays clean as you push the level. Where the DBR10 version of this rig covers a small room, the DBR12 pair covers a full band in a hall, a busy wedding floor, or a packed sanctuary. One purchase, mixer and speakers matched and ready to run.

8 MGX Preamps and 125 dB Dynamic Range Capture the Whole Stage

The MGX16 B carries 8 MGX premium mic preamps with an 86 dB gain range and 125 dB of dynamic range at the stereo output — enough clean headroom to mic a full band, a choir, and a podium without the noise floor creeping into quiet passages. Inputs run 8 combo Mic/Line, 4 TRS line, and 4 RCA line, mixing 16 channels across 1 STEREO, 8 MIX, 2 FX, and 1 CUE bus. The 8 MIX buses feed stage monitors and zone outputs independently of the main DBR12 pair, so the band hears one mix while the room hears another.

22-in/22-out USB Interface and Onboard 16-Track microSD Recording

A built-in 22-in/22-out USB audio interface streams every channel to a computer at 32-bit/96 kHz for multitrack recording, live streaming, or virtual soundcheck, with a separate 2-in/2-out USB SUB port for a second device. When there is no computer, the MGX16 B records 16 tracks straight to a microSD card at 24-bit — a full standalone multitrack backup of the show. A full DSP suite (Gate, Compressor, EQ, Reverb, Amp Sim, Voice Changer, Ducker, Multi-Band Compressor, and lip-sync Delay) plus 8 Sound Pads and Bluetooth audio input round out the console.

Two DBR12 12-Inch Speakers Deliver 131 dB SPL of Clean, Full-Range Output

Each Yamaha DBR12 drives a 12-inch LF cone and a 1.4-inch HF compression driver with 1,000W of Class-D bi-amplification, reaching 131 dB max SPL and a 52 Hz to 20 kHz frequency range — full-range enough that most program material needs no subwoofer. Yamaha proprietary FIR-X tuning applies a linear-phase crossover for tighter transient response than typical powered speakers, so vocals and kick stay defined even at high volume. The pair covers a 90-degree-wide audience and easily fills a 100-to-300-person venue.

D-Contour and a Symmetrical Cabinet Make Each DBR12 a Main or a Monitor

The DBR12's D-Contour switch toggles each cabinet between FOH (front-of-house) and Monitor (floor-wedge) DSP voicings with one button, and the symmetrical enclosure with a 35mm pole socket lets the same speaker stand upright on a pole or lie tilted as a stage monitor. Each cabinet also has a 2-channel onboard mixer (two XLR/TRS combo inputs plus RCA) and an XLR Mix-Out that daisy-chains the post-mix signal to the second speaker for a fast stereo PA. At 34.8 lb with an M10 fly point, the pair rigs into installs or loads out by hand.

For the Gigging Band, the Worship Tech, and the Mobile Event Pro

For the first-timer, this is a turnkey PA — plug mics into the MGX16 B, run two cables to the DBR12 pair, and the room is covered with room to spare. For the upgrader moving off a small powered-speaker setup, the 1,000W DBR12 pair adds the SPL and low-end the smaller boxes lacked while the MGX16 B adds recording, streaming, and scene recall. For the comparison shopper, this is the higher-output configuration of the MGX16 B system: 12-inch 1,000W cabinets and 131 dB SPL instead of the 700W DBR10 pair. Mixer, speakers, and software — one order, ready to run.