Yamaha DXR10 mk3 10-Inch 2000W 2-Way Powered Loudspeaker with DSP and Bluetooth

Yamaha DXR10 mk3: The 10-Inch Powered Speaker That Carries a Full Room and Still Fits in the Car

The Yamaha DXR10 mk3 is the most compact model in Yamaha's DXR mk3 powered loudspeaker series, and that is exactly why it gets picked up first. It pairs a 10-inch low-frequency cone and a 1.75-inch compression driver with a 2000-watt peak Class-D amplifier, then pushes 132 dB SPL of clean, controlled output out of a form-injection molded enclosure that weighs just 32 pounds. If you have been running a small mixer into underpowered speakers and fighting for headroom, this is the speaker that finally gives you room to breathe — loud enough for a packed bar, a wedding floor, or a worship room, light enough to carry in one hand.

How 32-Bit DSP and FIR-X Tuning Make a Compact Box Sound Bigger Than It Is

Inside the DXR10 mk3 is a 32-bit, 96 kHz DSP engine running Yamaha's Advanced FIR-X Tuning — a linear-phase FIR crossover set at 1.8 kHz that aligns the woofer and tweeter in time, not just in level. The result is a coherent, distortion-free sound where vocals sit forward and the low end stays tight instead of muddy. Drive Motion Calibration goes a step further, using a proprietary algorithm to correct the motion of the 10-inch cone in real time so bass tracks the input signal accurately even when you push the speaker hard. For the upgrader stepping off entry-level plastic boxes, this is the difference between sound that gets louder and sound that gets better.

Six DSP Modes and AUTO V/H Position Sensing — Setup That Thinks for You

The DXR10 mk3 carries six selectable DSP modes — FOH/Main, Monitor, DJ, Live Music, Speech, and Off — developed in collaboration with Yamaha group company NEXO. Stand it on a pole and it voices itself for front-of-house; lay it on its side as a 55-degree floor wedge and a built-in accelerometer detects the orientation and switches to Monitor mode automatically through the AUTO V/H Position function. DJ mode tightens the low end for music playback, Speech mode favors intelligibility for presentations, and the rear LCD panel with rotary encoder lets you recall presets, set the high-pass filter, and dial PEQ and delay without a laptop on site.

Bluetooth Streaming, D-Remote Control, and a Built-In Feedback Suppressor

Bluetooth 5.0 with A2DP lets you stream background music or a playlist straight to the speaker between sets, while the free D-Remote app for iOS and Android gives you wireless control of level, EQ, crossover, delay, feedback suppression, panel lock, and scene save and recall — across up to ten connected speakers at once. The Intelligent Feedback Suppressor runs in Dynamic mode for roaming handheld mics and Fixed mode for podiums and lecterns, so the squeal that ruins a speech or a toast gets caught before the room hears it. These are the tools a presenter, a house-of-worship volunteer, or a one-person mobile rig actually reaches for.

Built to Move: Two Combo Inputs, Daisy-Chain Outputs, and Real Rigging Points

Two combo XLR/TRS inputs accept everything from a mixer's line output to a handheld microphone — INPUT2 switches between Line and Mic level — and the XLR thru and DSP out jacks let you daisy-chain a second cabinet or feed a subwoofer without an extra splitter. A dual-angle pole socket offers a straight 0-degree or focused -7-degree down-tilt, top and side rigging points accept M8 eyebolts for permanent installs, and a rubber-coated top handle makes the 32-pound cabinet genuinely easy to carry. For the comparison shopper weighing a 10-inch active speaker, the spec sheet tells the story: 2000W peak, 132 dB SPL, 53 Hz low-end reach, and a Yamaha DSP platform in a box you can stack in the back seat.