high end Offset Bass Body Unfinished Deep Curly Maple Top / Walnut Accent/ Solid One-piece Mahogany Back- limited Luthier Supply R2

SALE! SALE!
Provenance & Craftsmanship

Each body was made from premium lumber hand-selected by a boutique luthier, who personally sourced and transported the wood to a professional shop in New Jersey for shaping. Specifications were tailored to his own playing preferences, making them compatible with standard hardware while offering a refined feel and build quality not found in mass-produced bodies.For example, the Cap or top of the bass bodies is much thicker then 1/8th inch. (Often the standard in available bass bodies.) The thicker top allows for more complex tones and frequencies. A thicker cap also shows more of the beautiful wood grains from the side view of the bass.

This is a New Old Stock (NOS) unfinished Offset bass body featuring a Deep Curly maple top, a walnut accent layer, and a solid mahogany back. A three-piece build for tone and stability.

Wood Type & Grain

Top: Deep Curly Maple

Accent: Walnut

Back: Solid one-piece mahogany — highly favored with bass players for its tonal warmth, sustain, and resonance.

Note: Contains genuine mahogany, subject to CITES restrictions for international shipping (U.S. shipping only).

Specifications

Compact Long-scale offset bass body style

Neck pocket compatible with standard 4-string bass necks

Neck mounting holes: Pre-drilled neck mounting holes are slightly larger than standard to accommodate threaded inserts - Approximately 1/4"

Control cavity and pickup routes: standard dual-pickup configuration

Bass body created for use with vintage style or similar bridges. 

Weight: 5 lbs 3.2 oz (scale was set to to tenths ... 5.2 pounds.)

Inventory: R2

Condition

• There is a darker area on the back (see photos) and the surface feels slightly less smooth then some other bodies from this batch. Both are typical for unfinished flame Maple/ laminate builds and can be addressed easily during final sanding and prep before finishing.

• There is a small visible seam along part of the maple/ walnut join (see close up photo) This is a normal occurrence in older NOS laminate bodies and will not affect stability. It can be filled or smoothed during final prep if desired.

• very small impression on side of body. I actually cannot find it now to verbally describe it, but I did take a picture.

• Unfinished NOS body, stored in climate-controlled workshop. Excellent structural integrity with natural grain variations.

Tone & Workability

1 1/2” thick body — light yet maintains a vintage feel

Belly contour

No pre-drilled jack hole — install through control cavity if desired

Control cavity: front-routed, no pickguard route

Deep cavity — fits standard or active pickups

No forearm contour

Certain models include vintage-style holes below pickups. The holes on this particular guitar are straight except for the Center. One seems a little bit raised. See the photos. It’s an easy fix if you need to slightly adjust the alignment of the holes.

Vintage-style neck route

Shallow neck pocket — great for pop/slap styles

Full 34” scale

Truss rod access at neck pocket

Bookmatched maple tops on all models

Dimensions

Body length: 19 1/2"

Body width: 13 1/2" (widest point)

Body thickness: 1 1/2"

Neck pocket: approx. 2 1/2" wide × 3 7/8" long × 5/8" deep

Additional Info

No hardware or electronics included

Packaged with care

Ask all question prior to purchase.

Returns accepted within 7 days; buyer pays return shipping; must be in original, unaltered condition