The dbx 1231 is a two-channel, 31-band graphic equalizer with 1/3-octave bands on ISO center frequencies. It is built for demanding sound reinforcement and installed systems, with straightforward controls in a 3U steel and aluminum chassis.

The 45 mm center-detent faders work over a selectable ±6 dB or ±15 dB range. Each channel has ±12 dB of input gain and a switchable 40 Hz low-cut filter. XLR, 1/4 in. TRS and barrier strip connectors ease installation, and a chassis/signal ground lift helps isolate hum. A hard-wired relay bypasses the unit when the power is off and waits 2 seconds after power-up before switching back in.

Features

  • Two channels of 31-band, 1/3-octave equalization on ISO center frequencies
  • 45 mm center-detent faders
  • Switchable ±6 dB or ±15 dB boost/cut range
  • ±12 dB input gain range
  • Switchable 40 Hz, 18 dB per octave Bessel low-cut filter
  • Electronically balanced inputs and servo-balanced outputs
  • RF-filtered inputs and outputs
  • XLR, 1/4 in. TRS and barrier strip connectors
  • Chassis/signal ground lift
  • Internal power supply transformer
  • Power-off hard-wire relay bypass with a 2-second power-up delay

Specifications

  • Channels: 2
  • Bands: 31 per channel, 1/3-octave, ISO centers
  • Input Connectors: 1/4 in. TRS, female XLR (pin 2 hot) and barrier strip
  • Input Type: Electronically balanced/unbalanced, RF filtered
  • Input Impedance: 40k ohms balanced, 20k ohms unbalanced
  • Maximum Input Level: More than +21 dBu, balanced or unbalanced
  • CMRR: More than 40 dB, typically more than 55 dB at 1 kHz
  • Output Connectors: 1/4 in. TRS, male XLR (pin 2 hot) and barrier strip
  • Output Type: Impedance-balanced/unbalanced, RF filtered
  • Output Impedance: 200 ohms balanced, 100 ohms unbalanced
  • Maximum Output Level: More than +21 dBu into 2k ohms or greater; more than +18 dBm into 600 ohms
  • Bandwidth: 20 Hz to 20 kHz, +0.5/-1 dB
  • Frequency Response: Under 10 Hz to over 50 kHz, +0.5/-3 dB
  • Signal-to-Noise Ratio: More than 90 dB, ref. +4 dBu
  • THD+Noise: Less than 0.005%, 1 kHz at +4 dBu
  • Interchannel Crosstalk: Below -80 dB, 20 Hz to 20 kHz
  • Boost/Cut Range: ±6 dB or ±15 dB, recessed switch
  • Low-Cut Filter: 40 Hz, 18 dB/octave Bessel high-pass, recessed switch
  • Meters: 4-LED bar graph at -10, 0, +10 and +18 dBu
  • Power Consumption: 24 W
  • Power Connector: IEC receptacle
  • Rack Space: 3U
  • Dimensions (H x W x D): 5.25 x 19 x 7.9 in. (13.4 x 48.3 x 20.1 cm)
  • Weight: 10.6 lb (4.8 kg)

In the Box

  • dbx 1231 graphic equalizer
  • AC power cord
  • Operation manual
  • Registration card
  • Four rack mount screws and washers

CondizioneNuovo (Nuovo)
Gli articoli "Nuovi” sono venduti da un rivenditore autorizzato o dal produttore originale e comprendono l’imballo originale.Scopri di più
Marchio
Modello
  • 1231 Dual Channel 31-Band EQ
Finish
  • Graphic
Categorie

Le informazioni sulla sicurezza del prodotto sono disponibili qui.

Informazioni sul venditore

Blackout Audio

Toronto, Canada
Iscrizione a Reverb::2023

Protezione di Reverb

Resi semplici, transazioni sicure, assistenza di persone in carne e ossa

Scopri di più

Checkout sicuro

Annunci simili in promozione













Recensioni del prodotto

Reverb Gives

Con i tuoi acquisti dai un contributo ai programmi musicali rivolti ai giovani, aiutandoli a ricevere gli strumenti di cui hanno bisogno.

Ops, forse hai dimenticato qualcosa. Verifica i campi evidenziati in rosso.