The WA-C1 Mod brings the most celebrated all-analog chorus and vibrato circuit into a significantly smaller, pedalboard-friendly enclosure with top-mounted jacks. The 100% analog preamp that gives the original its bite is now fully bypassable for rigs with careful gain-staging, and the chorus gains separate depth and rate controls that go beyond the fixed-depth vintage units, while the rich three-dimensional vibrato stays true to the original.

Features

• 100% analog stereo chorus and vibrato built on a premium MN3007 BBD chip recreation
• Bypassable analog preamp: Vintage mode keeps the classic always-on preamp, Modern mode takes it out of the path
• Separate chorus Depth and Rate controls where vintage units only had a fixed-depth Intensity knob
• Rotary-flavoured vibrato mode with a flashing LED showing the engaged effect and modulation rate
• Selectable rear-panel impedance: vintage 50 kΩ or 1.1 MΩ Hi-Z for passive instruments, active in bypass too
• High/Low input sensitivity and preamp level control; dual DC-DC converter delivers vintage-correct internal voltage
• Wet/dry stereo output from a single input; hand-tested in Austin, TX with a 5-year warranty

Specifications

• Controls: High/Low input sensitivity, preamp level, chorus depth and rate, vibrato depth and rate, chorus/vibrato switch, Vintage/Modern preamp switch, Hi-Z on/off
• Jacks: one input, two outputs (stereo wet/dry)
• Power: 200 mA at 9 V via dual DC-DC voltage converter
• Dimensions: 4.5″ × 2.8″ × 2.4″, 1 lb