Melbourne Instruments Roto-Control Stand

A pair of angled supports that clip over each end of Roto-Control and tilt it 30 degrees towards you. It's a small change that does more than it sounds like. Adding stands means the knobs come under your hand rather than out in front of it. Every knob's display faces you instead of making you lean over the desk. Over a three-hour session, that adds up.

They clip on and lock. Pick the unit up by the ends and the stands come with it, rather than dropping off onto the desk behind you. Nothing spans the middle. Two separate ends, so the rear ports stay clear and the cable runs where you want it, and the sides close around the unit instead of leaving it perched on open legs.

Look underneath and the bracing is the Melbourne Instruments waveform, holding the ramp up. With silicone on each stand, they stay where you put them, on a desk or on a shelf above a keyboard.

Using PETG throughout, the stands are robust, with enough give to snap on without marking the unit. 81 g the pair.

These official stands are designed and made by the same people as Roto-Control. Supplied as a pair, left and right, in black.