Audio-Technica AT-LP60XBT-BK Bluetooth Belt-Drive Turntable with Pioneer DJ DM-50D-W 5-Inch Powered Monitors and 13-Foot Stereo RCA Cable

Audio-Technica AT-LP60XBT-BK Bundle: A Complete Vinyl Listening System in One Box

Most turntables arrive with one obvious problem unsolved: you still cannot hear anything. The AT-LP60XBT-BK is a fully automatic belt-drive turntable, but a turntable alone is just a spinning platter until it is connected to speakers. This bundle closes that gap. It pairs the AT-LP60XBT-BK with a pair of Pioneer DJ DM-50D-W 5-inch powered monitors and the 13.1-foot Hosa CRA-204 dual RCA cable that wires them together. Pull everything out of the box, set the turntable next to the speakers, run the cable, drop a record, and the music plays. There is no separate amplifier to buy, no receiver to source, and nothing left to figure out — which is exactly what a first-time vinyl buyer or an upgrader leaving a basic all-in-one player needs.

Fully Automatic Operation Means You Touch the Record, Not the Tonearm

The AT-LP60XBT-BK runs the tonearm for you. Press start and it cues to the lead-in groove, lowers gently onto the record, and at the end of the side it lifts, returns, and stops the platter automatically. There is no hand-guiding a stylus onto delicate vinyl and no fingerprints near the cartridge. For anyone nervous about damaging a record or a needle, automatic operation removes the single most intimidating part of playing vinyl. It also means the side never plays out into a locked groove all night if you walk away — the turntable shuts the platter down on its own.

Bluetooth aptX and a Built-In Preamp Give You Two Ways to Listen

This turntable is built to be flexible about how the sound gets out. A built-in switchable phono/line preamp lets it drive the included powered monitors directly through the RCA cable — set the switch to line and the signal is ready for active speakers with no external phono stage. Flip it to phono and it feeds a traditional stereo receiver instead. When you want to go cable-free, the AT-LP60XBT-BK transmits over Bluetooth with aptX codec support, so you can send a record to a Bluetooth speaker in the kitchen or a pair of wireless headphones late at night without disturbing anyone. The wired monitors handle critical, full-range listening; Bluetooth handles convenience.

Die-Cast Aluminum Platter and VM Cartridge for Tracking That Stays Clean

An anti-resonance die-cast aluminum platter gives the record a stable, vibration-damped surface, which keeps wow and flutter low (under 0.25% WTD at 3 kHz) and reduces the rumble that muddies bass. The integral VM-type dual moving magnet cartridge ships with a replaceable ATN3600L diamond stylus — a genuine upgrade path, because you can swap the stylus when it wears rather than replacing the whole cartridge. A redesigned tonearm base and headshell improve tracking and cut resonance, and the external AC adapter keeps power-supply conversion noise out of the chassis and away from the audio signal.

Pioneer DJ DM-50D-W Monitors: Real Powered Speakers, Not a Built-In Toy Driver

The DM-50D-W pair are active 5-inch monitors — each cabinet houses a 5-inch fiberglass woofer and a 3/4-inch soft-dome tweeter driven by 25W-per-channel Class D amplification, hitting 106 dB SPL across a 60 Hz to 20 kHz range. A 96 kHz DSP gives you two voicings: DJ mode adds low-end weight for a fuller, punchier sound, and Production mode flattens the response for accurate, reference-style listening. DECO convex diffusers spread the highs across a wider area so the stereo image stays solid even when you are sitting close at a desk, and a front-panel 1/8-inch headphone output with its own level knob lets you listen privately without reaching behind the cabinet. These are speakers that reveal what is actually in the groove.

The Hosa CRA-204 Cable Is the Piece People Forget to Buy

A turntable and a pair of powered speakers do nothing until something connects them, and the factory cable on most turntables is too short to reach speakers placed across a desk or shelf. The Hosa CRA-204 solves that: a 13.1-foot dual RCA to dual RCA interconnect with oxygen-free copper conductors and OFC spiral shielding that rejects the hum and buzz a long cable run can otherwise pick up. Nickel-plated plugs seat firmly in the jacks and resist corrosion. It carries the full stereo signal from the turntable's line output to the monitors' RCA inputs in a single, generously long run — so speaker placement is your choice, not the cable's.

How the Three Pieces Work Together as One System

The chain is simple and complete: the AT-LP60XBT-BK reads the record and, with its preamp switched to line, sends a ready-to-amplify signal down the Hosa CRA-204 cable into the DM-50D-W monitors, which power and reproduce it. Every connector matches — the turntable's RCA line output, the cable's RCA ends, and the monitors' RCA inputs — so there are no adapters to hunt down. Want to move the music to another room? Bluetooth aptX is built in. Want a private late-night session? The monitors have a headphone jack. The system gives you wired full-range listening, wireless convenience, and private monitoring without buying a single extra part.

For the First Vinyl Buyer, the Upgrader, and the Listener Who Just Wants It to Work

If this is your first turntable, this bundle is the easiest possible start — automatic operation, a built-in preamp so you do not need to understand phono stages, and speakers and a cable already in the box. If you are upgrading from a suitcase-style all-in-one player, the separates-quality belt drive, die-cast platter, and real powered monitors are an immediate, audible step up. And if you simply want to play records without assembling a component system, everything here is matched, connected, and ready. One purchase, one evening of setup, a lifetime of records.