Crown X1000 Stereo 2x300W Power Amp

Crown X1000 Power amp in excellent condition. This one has lived it's life in a rack case which is included.

X1000 Stereo 2x300W Power Amp Specifications:

• Guaranteed Minimum Power: 300W (per channel) @ 4 ohms / 200W (per channel) @ 8 ohms / 600W bridge mono @ 8 ohms
• Frequency Response (at 1 Watt): 20Hz - 20kHz, +0/-1dB
• Total Harmonic Distortion (THD): < 0.5%, 20 Hz - 20 kHz
• Intermodulation Distortion (IMD) 60Hz and 7kHz at 4:1, from full rated output
• to “30 dB: 0.35%
• Slew Rate: >10V/us
• Voltage Gain: 29dB 31dB 33dB 36dB
• Damping Factor (8 ï“), 10Hz - 400Hz > 200
• Signal-to-Noise Ratio: (below rated power,
• 20 Hz to 20 kHz, A-weighted): > 100dB
• Crosstalk (below rated power)
• At 1 kHz: “75dB
• At 20 kHz: “59dB
• Input Sensitivity for full rated power at 8 ohms 0.775V or 1.4V
• Input Impedance (nominal)
• Balanced: 20 kOhms
• Unbalanced: 10 kOhms
• 
  Connectors, Controls and Indicators
• Input Connectors: One balanced XLR and one unbalanced RCA per channel
• Output Connectors: (Speaker Connectors) 4-POLE Speakon and one pair Binding Post per channel
• Front Panel Controls: Power on/off switch, one gain control per channel
• Rear Panel Controls Output mode switch: stereo (dual), parallel or bridge
• Input sensitivity switch: 0.775V or 1.4V
• Power Indicator: One blue LED
• Signal Indicator: One green LED per channel
• Clip (peak) Indicator: One yellow LED per channel
• Fault Indicator: One red LED per channel
• 
  Construction
• Protection: Protection against short circuits, no-load, on/off muting,
• RF interference. Stable into reactive or mismatched loads
• Ventilation: Flow-through ventilation from front to back
• Cooling: Internal heat sinks with forced air. Fan cooled,
• speed regulated, thermal protection