Quirky partscaster with premium parts and a fancy “Craig Anderton” style electronic harness- explained at the end.

USA neck, fender staggered locking tuners, Seymour Duncan rails humbucker, other pickups I’m not sure but they’re nice, staggered poles- probably from Fender USA or MIM. Body is not Fender brand. Thick steel trem block

I left three pickguard screws undrilled for style reasons and didn’t drill the spring cavity cover holes either.

The application of window cling film stained glass went reasonably well, up close there are some flaws that are visible. Just wasn’t digging the 3 tone sunburst. Probably could be removed easily 

This one’s good where it counts and has a rugged sort of refinement to it. Neck position sounds great. Small finish ding on the neck, 3 way switch drilling and tip fitment are a little roughly done 

The wiring:

5 way switch with 3 way switch. 

The three way switch goes:

bridge -bridge + middle - middle

Then the 5 way switch goes:

1. 3 way switch

2. Neck+ 3 way

3. Neck only

4. Neck with bass cut resistor

5. Neck in series with 3 way