Decksaver DS-PC-DDJREV5: Keep Your DDJ-REV5 Gig-Ready Between Every Set

The Decksaver DS-PC-DDJREV5 is a custom-molded protective cover built for one job: keeping a Pioneer DJ DDJ-REV5 in showroom condition. Cut to the exact footprint of the controller, it drops straight over the unit — no straps, no clips, no fasteners — and forms a hard polycarbonate barrier over the jog wheels, faders, performance pads, switches, and knobs that take the most abuse. Whether the REV5 lives on a desk, rides in a bag to gigs, or sits in a smoky booth, this cover takes the dust, spills, and knocks so the controller doesn't.

Super-Strong Smoked/Clear Polycarbonate That Lets You See the Layout

Decksaver's signature smoked/clear polycarbonate is the difference between a generic dust sheet and real protection. The shell is rigid enough to absorb impact and resist pressure if something heavy lands on top of the controller in transit, yet transparent enough that the DDJ-REV5's control layout shows through. For a comparison shopper deciding between a soft slip cover and a hard shell, that rigidity is the whole point — a soft cover keeps dust off but does nothing when the controller gets crushed in a packed car or flight case.

Dust, Liquid, Smoke, and Impact — Sealed Out in One Piece

A DDJ-REV5 that lives out on a desk collects dust in the faders and crossfader gap, and a single drink spill at a party can end a session. This cover seals the top surface against all four threats — dust, liquid, smoke, and accidental impact. For the home DJ who leaves the controller set up between practice sessions and the content creator filming in a lived-in space, that means the REV5 is protected 24/7 without having to box it up after every use.

Low-Profile and Cable-Friendly for Permanent and Mobile Setups

At just 1.7 inches tall and 2.4 pounds, the DS-PC-DDJREV5 is low-profile enough to fit inside most flight cases and travel bags with the cover still on the controller — so the REV5 gets a double layer of protection on the road. It also seats cleanly with cables connected, so a DJ running a permanent wired setup can leave the master outputs, mic, and USB plugged in and still drop the cover on top when the session ends. One cover handles both the desk and the gig bag.