There are so many reasons to add the JHS Pedals Buffered Splitter to your pedalboard. But the most important one is great tone. If you’ve ever split your guitar’s signal with a passive device, adapter, or even certain effects pedals, you know that the results can sometimes be less than stellar. This happens because many of those products simply cut your tone in two, sending one half one way and the other half the other way. You can end up with a tone that is muddy and lifeless. Adding our Buffered Splitter to your chain not only avoids these issues, but it will perfectly drive your long cable runs and pedalboard chains as well. Trust us on this one. If you need to split your signal for any host of reasons, putting our Buffered Splitter on your board will give you your tone back. Simple and effective signal-splitting device There are a ton of applications for adding a Buffered Splitter to your signal chain. Whether moving a tuner out of line or running a dual-amp setup, once you use the JHS Buffered Splitter, you’ll never be without one again. Here are just a few options. - Send one signal to a tuner that is out of the signal chain while retaining your full tone - In a dual-amp setup, both amplifiers will see a powerful, clean signal - Bassists can send one side to their amplifiers, while sending the other to the board Keeps your tone clear, powerful, and pristine If you’re as pedal happy as we are at JHS, you’re going to want this quality b