The Katana Clean Boost is back and better than ever!
The new Katana uses the original JFETs that made the original so special. Using the same component values from the original Katana and updating the Boost mode offers a more robust, clear sound, giving more clarity to bass notes when engaged.

The Katana Boost is also a fat, harmonically rich boost, just pull out on the volume knob and push the limits with overdriven tone! You can keep it on all the time to push your amp harder, or as an occasional boost to cut through the mix.

Want a mirror image of your tone, only louder? Roll the volume knob forward with your foot and you’ll be good to go! NEED EVEN MORE? The Katana Boost is also a fat, harmonically rich boost, just pull out on the volume knob and push the limits with overdriven tone! You can keep it on all the time to push your amp harder, or as an occasional boost to cut through the mix.

Two modes, Pure Clean and High Gain

1. With the speed knob Pushed In, think of it as a volume control that goes to 20.
2. With the speed knob Pulled Out, it’s a cutting boost with a bit of gain. Not quite an overdrive, just overdriven tube grit and edge to your tone. This setting can add up to +30db boost – It will make your signal sing.

Voltage Doubling

Dual FETs for the most tube like tone in a transistor design. Power Doubling on the inside so you put 9VDC in, and we use a charge pump to nearly double operating voltage! CAUTION – 9 Volt DC Maximum Input Voltage – DO NOT try to put 18 volts to the unit hoping that the doubler will make it 36VDC!

• 76 mm wide 111 mm high

PreAmp

Found Sound Australia Pty Ltd.
110 Albert St
Brunswick East, VIC 3057
Australia