The SA-412-Slant delivers that classic half-stack sound you've been chasing. Four 12-inch speakers in a slanted baffle design — the upper two angled toward your ears for monitoring, the lower two firing straight at the audience. It's the setup that built rock and roll, and it still works.

These custom drivers pack 30-ounce magnets with 2-inch Kapton voice coils, handling 400 watts RMS without breaking a sweat. Whether you're pushing a cranked tube head or running a high-wattage solid-state amp, you'll get clean headroom when you need it. The 8-ohm impedance plays nice with most guitar heads, and 96 dB sensitivity means efficient power transfer — your amp's watts turn into actual volume.

The frequency response runs 45Hz to 5kHz, capturing the fundamental punch and harmonic content that defines electric guitar. That 5/8-inch plywood front baffle isn't just for looks — it provides the structural backbone for tight, punchy low-end response. At 71 pounds, it's substantial enough to handle the punishment of high-SPL gigs but still manageable for two-person load-ins.

This cabinet shines in clubs, theaters, and outdoor festivals. You can run it standalone for venues up to 500 people, or pair it with a straight 4x12 underneath for the full stack experience. The recessed handles and metal corner guards will survive the usual van abuse, and the dual input jacks let you daisy-chain or run parallel connections as needed.

Bottom line: If you need a traditional slant 4x12 that delivers classic rock tone without boutique pricing, this gets the job done reliably night after night.

Technical Specifications

• Power (RMS): 400 Watts
• Power (Peak): 800 Watts
• Woofer: Four 12" with 30 oz magnet, 2" Kapton voice coil
• Frequency Response: 45Hz - 5kHz
• Sensitivity: 96 dB
• Impedance: 8 Ohms
• Inputs: Two 1/4" jack inputs
• Cabinet: 5/8" plywood front panel, black carpet
• Dimensions: 29" H x 29" W x 14" D
• Weight: 71 lbs
• Warranty: 1 Year

Frequently Asked Questions

Will this match my guitar amp head's impedance?

This 8-ohm cabinet works with most guitar heads including Marshall, Mesa Boogie, Orange, Peavey, and Fender models. Just make sure your amp's output impedance matches — never run mismatched impedances as it can damage your amp.

Do I need a straight cabinet underneath or can I use this alone?

It works great standalone for most venues up to 500 people. The traditional full stack setup (slant on top, straight on bottom) gives you more volume and stage presence, but this slant cabinet handles clubs and theaters just fine on its own.

What kind of speaker cable do I need?

Use a proper speaker cable (not an instrument cable) with 12 or 14 gauge wire rated for your amp's power output. Connect to either 1/4-inch input jack — they're wired in parallel.

How does the slant design affect my stage sound?

The angled top speakers point toward your ears for better monitoring, so you hear your tone clearly without cranking the volume. The bottom speakers fire straight out to the audience. It's the best of both worlds — you stay in the mix without overpowering the stage.