Includes microphone, original packaging, roadcase, thread. Craddle not included

Hand-crafted with the highest attention to detail, built with a roadworthy die-cast all-metal housing, metal switches, and rugged spring steel wire mesh grille that can take a beating during day-to-day tour life. The sE4400 appeals with its down-to-earth elegance, offering discrete electronics prioritizing the features you really need.

• Hand-crafted true condenser capsule individually tuned in our own factory
• Classic vintage sound and all-metal housing
• Switchable pickup patterns, cardioid, omnidirectional, figure-eight, and hypercardioid
• Innovative close-miking shockmount
• 40 / 80 Hz bass-cut filters and -10 / -20 dB pads
• Capsule: Hand-crafted 1" Gold-sputtered True Condenser
• Diaphragm: Gold-sputtered mylar
• Electrical impedance: 22 Ohms
• Connectivity: 3-pin male XLR connector
• Powering: 48V Phantom Power (P48 according to IEC 61938)
• Polar patterns: Cardioid, Hypercardioid, Omni-directional, Figure-8
• Frequency range: 20 Hz - 20 kHz
• Sensitivity: 25 mV / Pa (-32 dBV)
• Max SPL: 137 / 147 / 157 dB (0/10/20 dB Attenuation pad - 0.5% THD)
• Equivalent noise level: 13 dB(A)
• Signal to noise ratio: 81 dB
• Low-cut filter: 40 / 80 Hz, 6 dB/Oct, switchable
• Attenuation pad: 10 / 20 dB, switchable
• Mic weight: 290 g (10.23 oz.)
• Mic length: 146 mm (5.75 in.)
• Mic width: 58 mm (2.32 in.)
• Mic diameter: 29 mm (1.10 in.)

Tested and under warranty. Every preloved item is serviced, repaired if needed, and tested by our techs before it goes on sale. Used gear comes with our warranty: 3 months for electrical faults and 6 months for structural faults. It excludes misuse, neglect, unreasonable wear and service items such as strings and batteries. It's on top of your rights under the Australian Consumer Law.

---

Southside Guitars Brisbane
16 Chrome Street
Salisbury, QLD 4107
Australia