• Three-channel tube top from the Laney Ironheart series.
• 3 channels (Clean, Rhythm & AMP, Lead) with separate EQs
• All EQ controls with push/pull switch for additional tone options
  (Treble - Shift, Middle - Shift, Bass - Deep)
• High-Power-Mode with 300 watts or <1 watt of power
• Low-Power-Mode with 60 watt or <1 watt power output
• Push/Pull control for watt power regulation
• Power amplifier with two ECC83 tubes
• Cab rig speaker simulation
• Switchable pre-boost and integrated digital reverb effect
• Serial FX loop with adjustable level and bypass
• Integrated load resistor allows operation without connected speakers
• Balanced DI output with switchable speaker simulation, EQ and ground lift
• USB2.0 port and interface function, compatible with PC/MAC/iPad/Android
• Smartphone and MP3 AUX input
• Footswitch connection (5-pin DIN jack and 2x stereo jacks)
• Combi Speaker-Twist speaker connection with switchable impedance ( 4-8 Ohm or 16 Ohm)
• Rack enclosure
• FS4-IRT footswitch, 3m footswitch cable and power supply included
  
  

Even lighter yet packed with power, the Laney Ironheart IRT-SLS electric guitar amp impresses with 3 channels, separate 3-band EQs and two power modes that promise up to 300 watts of power. With two ECC83 tubes and a wide range of connection options, the IRT-SLS is a powerful all-rounder for on the road, in the studio, or at home, weighing only 3.5 kg. Quite simply, the IRT-SLS can be used as an interface thanks to its USB port and balanced DI-out and does not need an external speaker due to the integrated load resistor.

The channels of the Laney Ironheart IRT-SLS(Clean, Rhythm and Lead) can be adjusted with their own push/pull EQ controls. Lead and Rhythm Gain inject the right amount of Distortion into the sound, and if that's not enough, the built-in pre-boost switch can be used to turn the tubes up to full speed. Furthermore, the IRT-SLS offers a reverb function and an adjustable wattage through which with Push/Pull controls in low-power mode up to 60 watts and in high-power mode up to 300 watts can be achieved.

Like its predecessors of Laney's Ironheart series, the IRT-SLS electric guitar amplifier is specifically tailored to any recording needs. The balanced DI output on the rear panel can be adjusted with its own Level control and also features a cab emulation switch with two presets and a ground lift switch against unwanted noise. The USB 2.0 port turns the IRT-SLS into an interface with its own re-amp output jack for previously recorded audio tracks. In addition, the rear panel features a speaker jack, a headphone jack with its own volume control, an AUX input for external devices, an FX loop and a connector for the included FS4-IRT footswitch.